If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
3.3L V6 Engine Issues
The engine in my '92 Grand Caravan LE AWD will not start.
Yesteday i changed the thermostat and its now having this problem. Before changing the thermostat it ran perfectly. This is what ive worked out: - ECU does not report any engine failure codes (only 12 & 55), but the engine also has not ran since the ECU was last reset (so explains the lack of error codes?). - The injector relay does turn on, but injectors are not firing on cranking - There is no spark on cranking - Fuel pump appears to be working So i guess this points to a cam (does it have a cam sensor?) or crank sensor issue? I gather the ECU is ok as i do get the 12 and 55 fault codes, and the fuel pump does turn on. Can anyone tell me exactly where to find the cam and crank sensors? I know the crank sensor is meant to be located somewhere around the top of the bellhousing where it meets the block, but for the life of me, i cant find it (maybe hidden by the exst manifold??). Thanks! |
Ads |
#2
|
|||
|
|||
3.3L V6 Engine Issues
-- "Mark Williams" > wrote in message ups.com... > The engine in my '92 Grand Caravan LE AWD will not start. > Yesteday i changed the thermostat and its now having this problem. > Before changing the thermostat it ran perfectly. > > This is what ive worked out: > - ECU does not report any engine failure codes (only 12 & 55), but the > engine also has not ran since the ECU was last reset (so explains the > lack of error codes?). > - The injector relay does turn on, but injectors are not firing on > cranking > - There is no spark on cranking > - Fuel pump appears to be working > > So i guess this points to a cam (does it have a cam sensor?) or crank > sensor issue? > I gather the ECU is ok as i do get the 12 and 55 fault codes, and the > fuel pump does turn on. > > Can anyone tell me exactly where to find the cam and crank sensors? > I know the crank sensor is meant to be located somewhere around the top > of the bellhousing where it meets the block, but for the life of me, i > cant find it (maybe hidden by the exst manifold??). > > Thanks! > The cam sensor connector is attached to the Alternator mount bracket next to the side motor mount, it is near the thermostat you just replaced, see if you knocked the connector loose Glenn Beasley Chrysler Tech |
#3
|
|||
|
|||
3.3L V6 Engine Issues
Oh, everything was running fine, besides a overheating issue which
pointed to a bad thermostat. Hence why it was replaced. |
#4
|
|||
|
|||
3.3L V6 Engine Issues
Mark Williams wrote:
> The engine in my '92 Grand Caravan LE AWD will not start. > Yesteday i changed the thermostat and its now having this problem. > Before changing the thermostat it ran perfectly. So the question to ask yourself, is what did you mess up while changing the thermostat? Did you unhook any wires or vacuum hoses to gain better access? Knock something off with a wrench while changing the thermostate? Think through you procedure and see if you can remember unhooking something, slipping with a wrench, etc. It is fairly unlikely that your engine just coincidentally failed when you changed the thermostat. Possible, yes, but not probable. Probability favors something that happened related to the thermostat replacement. Matt |
#5
|
|||
|
|||
3.3L V6 Engine Issues
"Mark Williams" > wrote in message ups.com... > The engine in my '92 Grand Caravan LE AWD will not start. > Yesteday i changed the thermostat and its now having this problem. > Before changing the thermostat it ran perfectly. this is the problem, if it ran fine why mess with it? |
#6
|
|||
|
|||
3.3L V6 Engine Issues
-- "Mark Williams" > wrote in message ups.com... > The engine in my '92 Grand Caravan LE AWD will not start. > Yesteday i changed the thermostat and its now having this problem. > Before changing the thermostat it ran perfectly. > > This is what ive worked out: > - ECU does not report any engine failure codes (only 12 & 55), but the > engine also has not ran since the ECU was last reset (so explains the > lack of error codes?). > - The injector relay does turn on, but injectors are not firing on > cranking > - There is no spark on cranking > - Fuel pump appears to be working > > So i guess this points to a cam (does it have a cam sensor?) or crank > sensor issue? > I gather the ECU is ok as i do get the 12 and 55 fault codes, and the > fuel pump does turn on. > > Can anyone tell me exactly where to find the cam and crank sensors? > I know the crank sensor is meant to be located somewhere around the top > of the bellhousing where it meets the block, but for the life of me, i > cant find it (maybe hidden by the exst manifold??). > > Thanks! > Mark make sure you plugged the coil pack in all the way, I believe you removed that to access the thermostat Glenn Beasley Chrysler Tech |
#7
|
|||
|
|||
3.3L V6 Engine Issues
Punch wrote:
> "Mark Williams" > wrote in message > ups.com... > >>The engine in my '92 Grand Caravan LE AWD will not start. >>Yesteday i changed the thermostat and its now having this problem. >>Before changing the thermostat it ran perfectly. > > > this is the problem, if it ran fine why mess with it? Well that's real helpful! Bill Putney (To reply by e-mail, replace the last letter of the alphabet in my address with the letter 'x') |
#8
|
|||
|
|||
3.3L V6 Engine Issues
"Mark Williams" > wrote in message ups.com... > Well i now have it running intermittently. > > About 50% of the time itll start. > > When it does start sometimes itll run perfectly, other times itll > splutter at idle and wont rev very well. > A few times when it has been idling smoothly itll just stop dead... no > splutter and then die, itll just stop completeley. > > Engine codes are always 12, 55... so its not finding anything wrong. > > I guess cam and crank sensors would be the main suspects? > The cam sensor looks ok, i still havnt been able to find the crank > sensor. > Those two sensors is what I would suspect. Here's a pic of where the crank sensor is: http://freebsd-corp-net-guide.com/94tcpics/fig50.jpg Here's the entire project that documents this: http://freebsd-corp-net-guide.com/94tcpics/project.html Ted |
#9
|
|||
|
|||
3.3L V6 Engine Issues
The cam sensor is located just below the t/stat housing. disconnect
the plug and dry it out. if that doen't fix replace the cam sensor. look right above the water pump just to the left of center as you are looking at the engine. good luck On 17 Apr 2006 11:17:35 -0700, "Mark Williams" > wrote: >The engine in my '92 Grand Caravan LE AWD will not start. >Yesteday i changed the thermostat and its now having this problem. >Before changing the thermostat it ran perfectly. > >This is what ive worked out: >- ECU does not report any engine failure codes (only 12 & 55), but the >engine also has not ran since the ECU was last reset (so explains the >lack of error codes?). >- The injector relay does turn on, but injectors are not firing on >cranking >- There is no spark on cranking >- Fuel pump appears to be working > >So i guess this points to a cam (does it have a cam sensor?) or crank >sensor issue? >I gather the ECU is ok as i do get the 12 and 55 fault codes, and the >fuel pump does turn on. > >Can anyone tell me exactly where to find the cam and crank sensors? >I know the crank sensor is meant to be located somewhere around the top >of the bellhousing where it meets the block, but for the life of me, i >cant find it (maybe hidden by the exst manifold??). > >Thanks! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | June 8th 05 05:28 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | May 24th 05 05:27 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | May 8th 05 05:29 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 7 | February 1st 05 01:43 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |