If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
Sounds like you are missing the wire from the starter solenoid to the
coil that provides power to the ignition when cranking. The ICM only puts out voltage when the key is in run, not start. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's lucasred wrote: > > I've found that I only have 1 volt coming out of pin 4 ICM during cranking. > Manual calls for 90% of battery voltage during cranking. I follwed this > yellow with black striped wire to the PCM where it is located at pin 4 > there also. Tested voltage directly out of PCM - still 1 volt. Does anyone > know what function the pin 4 for either ICM or PCM is supposed to perform? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem starting car - No spark | The Outlander | Ford Mustang | 11 | July 20th 05 01:35 AM |
1994 Dodge Dakota coil | dodgedakota | 4x4 | 0 | March 12th 05 04:57 PM |
leaf springs | [email protected] | Corvette | 3 | March 10th 05 10:42 PM |
HELP!!! - Ignition coil problem on 99 LS1 | Christopher Martin | Corvette | 0 | October 10th 04 09:08 PM |