If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
throw out bearing replacement - 96 GT
Thinking I could drop the shaft at the rear, remove four bolts holding
the gearbox to the bell housing, shifter, cross-member.... slide the gearbox back. should be able to replace the bearing through the bell housing hole? Anyone tried it? Making a whining noise only when the clutch is depressed... assuming that's the throw out bearing. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
97 TJ 4.0L Clutch Won't Release - Throw Out Bearing Gone? | Tqm | Jeep | 20 | January 19th 06 02:04 AM |
throw out bearing | mcola | Mazda | 5 | December 2nd 05 10:15 PM |
Successful U-joint replacement on a 528e! | Steve Richfie1d | BMW | 8 | November 29th 05 04:58 AM |
Knocking sound with clutch in - replaced throw out bearing and still there | BeamGuy | Honda | 1 | November 23rd 05 05:25 PM |
63 roadster-rear spindle bearing replacement? | lib | Corvette | 1 | October 17th 05 06:14 PM |