If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
DexCool
What experience have people in this group had with GM's dexcool. My sons
Jimmy started to leak at the manifold and the dealer said it was because of the dexcool antifreeze used, of course GM said the dealer was wrong. Jack |
Ads |
#2
|
|||
|
|||
DexCool
"Jack Hayes" > wrote in message ... > What experience have people in this group had with GM's dexcool. My sons > Jimmy started to leak at the manifold and the dealer said it was because of > the dexcool antifreeze used, of course GM said the dealer was wrong. > > Jack This has been one of the longest threads on this newsgroup. Here is, in a nutshell, what I think we believe about DexCool: (I) Certain GM engines have problems that will likely lead to leakage, regardless of what coolant is used. These include certain 3800 V6's, and the 2.8,3.1, 3.4 V6's. The 3800 problem is different from the other series. It can leak because of a deteriorated plastic FI plenum and has nothing to do with Dexcool. (II)The other V6 series most likely leaks because of (1) some basic design problems and (2) because of the use of a gasket which does not hold up well. It has been claimed that this happened when GM went to a gasket that no longer contained asbestos. Others claim Dexcool is involved. I rather doubt that Dexcool is the culprit, but others swear it is. |
#3
|
|||
|
|||
DexCool
Seconded on all counts.
> wrote in message et... > > "Jack Hayes" > wrote in message > ... >> What experience have people in this group had with GM's dexcool. My sons >> Jimmy started to leak at the manifold and the dealer said it was because > of >> the dexcool antifreeze used, of course GM said the dealer was wrong. >> >> Jack > > This has been one of the longest threads on this newsgroup. > > Here is, in a nutshell, what I think we believe about DexCool: > (I) Certain GM engines have problems that will likely lead to leakage, > regardless > of what coolant is used. These include certain 3800 V6's, and the > 2.8,3.1, > 3.4 V6's. > The 3800 problem is different from the other series. It can leak because > of > a > deteriorated plastic FI plenum and has nothing to do with Dexcool. > > (II)The other V6 series most likely leaks because of (1) some basic design > problems > and (2) because of the use of a gasket which does not hold up well. It > has > been > claimed that this happened when GM went to a gasket that no longer > contained > asbestos. Others claim Dexcool is involved. I rather doubt that Dexcool > is > the culprit, but others swear it is. > > ----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==---- http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups ----= East and West-Coast Server Farms - Total Privacy via Encryption =---- |
#4
|
|||
|
|||
DexCool
Didn't Honda, Chrysler and Ford all nix Dexcool several years ago due to
increased incidence of gasket leaks when testing the stuff? I thought I read that somewhere 4-5 (or more) years ago. GM has a bad habit of allowing their corporate ego about a decision get between them and what the ultimate realities turn out to be (just personal experience). That could be the case here,...Dexcool be damned! |
#5
|
|||
|
|||
DexCool
Jack Hayes wrote: > What experience have people in this group had with GM's dexcool. My sons > Jimmy started to leak at the manifold and the dealer said it was because of > the dexcool antifreeze used, of course GM said the dealer was wrong. I've been using it in my 1992 Escort ever since it became available. So far, so good, despite the 1.9L Ford engine rather than the nice 1.8L Mazda one. I don't know what engine your son's Jimmy has, but if it's the 3.4L V-6, isn't there a secret warranty about the the famous intake manifold coolant leak problem? |
#6
|
|||
|
|||
DexCool
larry moe 'n curly wrote: > I've been using it in my 1992 Escort ever since it became available. > So far, so good, despite the 1.9L Ford engine rather than the nice 1.8L > Mazda one. You might want to see if some hick will swap you his complete 1.8 engine, harnass, and ECM. There's got to be someone out there that thinks "Murican is better!' even in this specific instance. Toyota MDT in MO |
#7
|
|||
|
|||
DexCool
Edward Strauss wrote: > Comboverfish > wrote: > > > larry moe 'n curly wrote: > > > > I've been using it in my 1992 Escort ever since it became available. > > > So far, so good, despite the 1.9L Ford engine rather than the nice 1.8L > > > Mazda one. > > > You might want to see if some hick will swap you his complete 1.8 > > engine, harnass, and ECM. There's got to be someone out there that > > thinks "Murican is better!' even in this specific instance. > He should swap out something that roughly 14 years old and doing fine > cause Jiponesse is better? I rarely drive the thing above 45 MPH anyway, and for 0-30 the 1.9L accelerates just as fast as the 1.8L. Plus the 1.9L doesn't bang valves if the timing belt fails. Rationalizing, rationalizing. |
#8
|
|||
|
|||
DexCool
Edward Strauss wrote: > He should swap out something that roughly 14 years old and doing fine > cause Jiponesse is better? You don't know much about these two engines, do you? Go ask someone that does know about the Ford 1.9. Ask them what a total piece of **** it is. Then try to find someone who can tell you one legitimate engineering problem with the 1.8 engine. I do like some Jiponeese (sic) vehicles, I like some Domestics, too. Please reread where I typed "in this specific instance" to grasp the correct context of the message. Also factor in sarcasm, if that's possible. Toyota MDT in MO |
#9
|
|||
|
|||
DexCool
On Wed, 8 Mar 2006, Jack Hayes wrote:
> What experience have people in this group had with GM's dexcool. VERY bad. The stuff is highly aggressive to many gasket and seal materials, even those specifically (nominally) designed for it. > My sons Jimmy started to leak at the manifold and the dealer said it was > because of the dexcool antifreeze used It was due to GM's shoddy design and build, *aggravated* by Dexcool. > of course GM said the dealer was wrong. Of course GM said the dealer was wrong. Dexcool is a real problem child for GM. DS |
#10
|
|||
|
|||
DexCool
Daniel J. Stern wrote: > On Wed, 8 Mar 2006, Jack Hayes wrote: >>What experience have people in this group had with GM's dexcool. >VERY bad. The stuff is highly aggressive to many gasket and seal >materials, even those specifically (nominally) designed for it. >>My sons Jimmy started to leak at the manifold and the dealer said it was >>because of the dexcool antifreeze used >It was due to GM's shoddy design and build, *aggravated* by Dexcool. >Of course GM said the dealer was wrong. Dexcool is a real problem child >for GM. I'm sure my 1986 Corolla wasn't designed specifically for Dex-cool, but I ran it in that car from the day it became available in retail stores until I sold the car 2 years ago. I never had external leaks (including crusting), sweet-smelling air from the vents, or a need to top off the overflow tank more than usual. This wasn't an exceptional case for Dex-cool because several company Chevy Novas and Geo Prizms (same engine as Corollas, but maybe GM radiators), were also run with Dex-cool, and a chemist who specializes in closed loop water cooling systems ran periodic checks and said the corrosion levels were low. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heater core -Al or Cu? | Jon C | Technology | 6 | January 23rd 06 05:32 PM |
Pesky radiator leak...can't decide what to do | [email protected] | Technology | 22 | December 1st 05 06:18 PM |
Pesky radiator leak...can't decide what to do | [email protected] | Honda | 23 | December 1st 05 06:18 PM |
THM400 2-3 shift hesitation; G-05 coolant and intake mfld gasket | Henry | Technology | 7 | March 16th 05 05:57 AM |
General Motors Dex-Cool problem | kr0 | Technology | 7 | March 4th 05 07:18 PM |