|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 27th 04, 10:57 PM
|
|||
|
|||
Hoover bit
The "Hoover bit" as described in Doghouse Oil Cooler Sealing Frame Fabrication (
http://www.type2.com/rvanness/sealfram.htm ), Dale Mueller made it out of aluminum angle can it be made out of thin aluminum ( like the material your soffit's are wrapped in ) and still work or does it need to be made out of heavier material like Dale used. David 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode