If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Best way to replace my stolen airbags?
"Patrick" <p.j.hughes@sbcglobal(dot)net> wrote in
.com: > The clock spring is under the steering wheel. Hmm. I guess the diagrams I was studying weren't too clear on that. It looked to me like it was part of the airbag assembly. Now that I think about it, it makes sense that it should be between the rotating part (the wheel) and the stationary part (the column). Thanks for the correction. -- TeGGeR® The Unofficial Honda/Acura FAQ www.tegger.com/hondafaq/ |
Ads |
#12
|
|||
|
|||
Best way to replace my stolen airbags?
It looks like they did a clean surgical removal of both bags. The yellow 2-pin connector seems intact. The bolts were left on the floor mat. Assuming I buy a pair of replacement airbags, how tricky is it to do the installation myself? Can a auto body shop do it? thanks _Adriano Patrick (dot) wrote: > The clock spring is under the steering wheel. All you should need is a new > bag unless they screwed up the connector on the wires that plug into the > connector on the air bag. Make sure you get the bolts that hold the bag in > place. > > "SoCalMike" > wrote in message > ... > > Dipsy wrote: > >> Thanks for the replies. > >> > >> One more question: What is the clock spring? How do I know if it's > >> missing too? > >> > >> Thanks > >> > > > > i think the clock spring is underneath the steering wheel. chances are, > > they just yanked the bags, real quick. |
#13
|
|||
|
|||
Best way to replace my stolen airbags?
Dipsy wrote:
> It looks like they did a clean surgical removal of both bags. > The yellow 2-pin connector seems intact. > The bolts were left on the floor mat. > Assuming I buy a pair of replacement airbags, > how tricky is it to do the installation myself? > Can a auto body shop do it? hard to say without the factory service manual, but i would surmise that disconnecting the battery and installing the new bags would be how ya do it. disconnecting the battery being of utmost importance, of course. |
#14
|
|||
|
|||
Best way to replace my stolen airbags?
I have seen some recommendations to remove the fuses that control the SRS
system too. Also let the system sit for 10-15 minutes after the battery is disconnected and fuses removed. I imagine this applies for when you are removing the air bag more so than putting it in but it can't hurt. I didn't have any problems removing mine and putting it back in. Since you have the screws and the connector is good you shouldn't have a problem doing it yourself. "SoCalMike" > wrote in message . .. > Dipsy wrote: >> It looks like they did a clean surgical removal of both bags. >> The yellow 2-pin connector seems intact. >> The bolts were left on the floor mat. >> Assuming I buy a pair of replacement airbags, >> how tricky is it to do the installation myself? >> Can a auto body shop do it? > > hard to say without the factory service manual, but i would surmise that > disconnecting the battery and installing the new bags would be how ya do > it. > > disconnecting the battery being of utmost importance, of course. |
#15
|
|||
|
|||
Best way to replace my stolen airbags?
I don't know about your year model but the 2001 and later have monitoring
of the air bag systems similar to the engine obdii system, after you replace the air bags you may have to reset the error codes. If you can't borrow a factory manual you may be better off taking it to a dealer after repairs to check error codes and reset if necessary.My manual (2001) says to disconnect the battery for three minutes before working on the airbags, it sure sems to be a better idea than disconnecting and reconnecting fuses because if you are under the hood connecting the battery you are out of reach of an airbag deployment, but may not be if you are in under the dash putting fuses back in-- airbags can seriously hurt you. dont take chances! "Patrick" <p.j.hughes@sbcglobal(dot)net> wrote in om: > I have seen some recommendations to remove the fuses that control the > SRS system too. Also let the system sit for 10-15 minutes after the > battery is disconnected and fuses removed. I imagine this applies for > when you are removing the air bag more so than putting it in but it > can't hurt. I didn't have any problems removing mine and putting it > back in. > > Since you have the screws and the connector is good you shouldn't have > a problem doing it yourself. > > "SoCalMike" > wrote in message > . .. >> Dipsy wrote: >>> It looks like they did a clean surgical removal of both bags. >>> The yellow 2-pin connector seems intact. >>> The bolts were left on the floor mat. >>> Assuming I buy a pair of replacement airbags, >>> how tricky is it to do the installation myself? >>> Can a auto body shop do it? >> >> hard to say without the factory service manual, but i would surmise >> that disconnecting the battery and installing the new bags would be >> how ya do it. >> >> disconnecting the battery being of utmost importance, of course. > > |
#16
|
|||
|
|||
Best way to replace my stolen airbags?
SoCalMike > wrote in
: > Dipsy wrote: >> It looks like they did a clean surgical removal of both bags. >> The yellow 2-pin connector seems intact. >> The bolts were left on the floor mat. >> Assuming I buy a pair of replacement airbags, >> how tricky is it to do the installation myself? >> Can a auto body shop do it? > > hard to say without the factory service manual, but i would surmise that > disconnecting the battery and installing the new bags would be how ya do > it. > > disconnecting the battery being of utmost importance, of course. I have several factory service manuals. I can scan a relevant page tonight and upload it. -- TeGGeR® The Unofficial Honda/Acura FAQ www.tegger.com/hondafaq/ |
#17
|
|||
|
|||
Best way to replace my stolen airbags?
That would be awesome. It's a 1996 Accord sedan EX 4cyl 4dr. thanks. TeGGeR® wrote: > SoCalMike > wrote in > : > > > Dipsy wrote: > >> It looks like they did a clean surgical removal of both bags. > >> The yellow 2-pin connector seems intact. > >> The bolts were left on the floor mat. > >> Assuming I buy a pair of replacement airbags, > >> how tricky is it to do the installation myself? > >> Can a auto body shop do it? > > > > hard to say without the factory service manual, but i would surmise that > > disconnecting the battery and installing the new bags would be how ya do > > it. > > > > disconnecting the battery being of utmost importance, of course. > > > > I have several factory service manuals. I can scan a relevant page tonight > and upload it. > > -- > TeGGeR® > > The Unofficial Honda/Acura FAQ > www.tegger.com/hondafaq/ |
#18
|
|||
|
|||
Best way to replace my stolen airbags?
"Dipsy" > wrote in
oups.com: > TeGGeR® wrote: >> >> >> I have several factory service manuals. I can scan a relevant page >> tonight and upload it. >> > > > > That would be awesome. It's a 1996 Accord sedan EX 4cyl 4dr. > thanks. > > And here y'go... <http://www.tegger.com/hondafaq/misc/manual_scans/accord/96_accord_srs.pdf> Note to all: I notice I've been posting a fair few scans from the manuals, so I've moved them all into a new folder called (what else) "manual_scans". Within that folder are now individual stores for each model. I see now how the "clock spring" is *most definitely* UNDER the steering wheel. The diagrams in the '96 Accord manual are far better than those in the '02 RSX manual, which is what I was studying when I originally posted a reply to Dipsy. It looks like the "clock spring" is essentially immune from damage unless a thief decides to cut the connector off instead of unplugging it. BTW, I'm gone until at least Wednesday. Being half-Canadian and kinda sorta half-American, I have to celebrate both Dominion Day and Independence Day all at the same time (which is hardship, I assure you). -- TeGGeR® The Unofficial Honda/Acura FAQ www.tegger.com/hondafaq/ |
#19
|
|||
|
|||
Best way to replace my stolen airbags?
Cool. Thanks and happy D & I days. -Adriano TeGGeR® wrote: > "Dipsy" > wrote in > oups.com: > > > TeGGeR® wrote: > > >> > >> > >> I have several factory service manuals. I can scan a relevant page > >> tonight and upload it. > >> > > > > > > > > That would be awesome. It's a 1996 Accord sedan EX 4cyl 4dr. > > thanks. > > > > > > > And here y'go... > <http://www.tegger.com/hondafaq/misc/manual_scans/accord/96_accord_srs.pdf> > > Note to all: I notice I've been posting a fair few scans from the manuals, > so I've moved them all into a new folder called (what else) "manual_scans". > Within that folder are now individual stores for each model. > > I see now how the "clock spring" is *most definitely* UNDER the steering > wheel. The diagrams in the '96 Accord manual are far better than those in > the '02 RSX manual, which is what I was studying when I originally posted a > reply to Dipsy. > > It looks like the "clock spring" is essentially immune from damage unless a > thief decides to cut the connector off instead of unplugging it. > > BTW, I'm gone until at least Wednesday. Being half-Canadian and kinda sorta > half-American, I have to celebrate both Dominion Day and Independence Day > all at the same time (which is hardship, I assure you). > > -- > TeGGeR® > > The Unofficial Honda/Acura FAQ > www.tegger.com/hondafaq/ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Safety Theory: Airbags: Why doesn't NASCAR use airbags? | [email protected] | Technology | 16 | December 3rd 05 03:18 AM |
96 Grand Caravan 3.8L A/C Evaporator Replace | RoadRunner | Chrysler | 2 | August 10th 05 03:39 AM |
Need to replace ECU on 97 Jetta Jazz, 2.0 ABA, automatic. | vinny | VW water cooled | 0 | July 21st 05 10:21 PM |
Replace the accessory belt on the Saturn L series | Newsguy | Saturn | 5 | June 16th 05 07:04 PM |
Help. How do I replace e34 (M50) leaking valve cover gasket. | wmjsplace | BMW | 1 | May 18th 05 06:16 PM |