If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Pinion angle... what's the secret?
I thought I had my pinion angle adjusted pretty well Sunday when I attached
the driveshaft, but I have a vibration that starts at about 40mph, dies off at around 50 and picks up again at about 60. My helper and I held a carpenters square (the big L shaped one) on the diff and lined it up that way, pointing directly at the output of the transfercase... Can anyone give tips that will get me dead on? n. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rack and Pinion failure | Tom B | Chrysler | 8 | January 29th 05 04:52 PM |
Does the Chrysler Corporation Car Production Broadcast paper show pinion bearing preload and pinion nut torque? | JP | Dodge | 6 | September 21st 04 02:16 AM |