If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cherokee Valve cover grommets?
I have an 89 Chero, 4.0 with metal valve cover. The dealer wants $50 for the
crankcase vent tube assembly. Does anyone have a source for the 90 degree grommet? I may just TIG weld an elbow opn and use straight oil hose. -- Stupendous Man, Defender of Freedom, Advocate of Liberty |
Ads |
#2
|
|||
|
|||
Cherokee Valve cover grommets?
In article >,
"Stupendous Man" > wrote: > I have an 89 Chero, 4.0 with metal valve cover. The dealer wants $50 for the > crankcase vent tube assembly. > Does anyone have a source for the 90 degree grommet? > I may just TIG weld an elbow opn and use straight oil hose. I think www.4wd.com has it in their catalog; I didn't see it online (but didn't look for long). $50, though, might not be that bad a price. |
#3
|
|||
|
|||
Cherokee Valve cover grommets?
Look down the isles of the Kragen, Pep Boys, Auto Zone. will
probably save you the time of making one. God Bless America, Bill O|||||||O http://www.billhughes.com/ Stupendous Man wrote: > > I have an 89 Chero, 4.0 with metal valve cover. The dealer wants $50 for the > crankcase vent tube assembly. > Does anyone have a source for the 90 degree grommet? > I may just TIG weld an elbow opn and use straight oil hose. > -- > Stupendous Man, > Defender of Freedom, Advocate of Liberty |
#4
|
|||
|
|||
Cherokee Valve cover grommets?
"L.W.(Bill) Hughes III" > wrote in message ... > Look down the isles of the Kragen, Pep Boys, Auto Zone. will > probably save you the time of making one. We do have one kragen in the county, no luck there or at the Napa stores. -- Stupendous Man, Defender of Freedom, Advocate of Liberty |
#5
|
|||
|
|||
Cherokee Valve cover grommets?
OK, it looks like a case of "parts guy failure". I found it on the NApa
website as "air intake ventilation" hose. $20. Cool.Cheaper than my time making one. http://www.napaautoparts.com/masterp...ke+Ventilation -- Stupendous Man, Defender of Freedom, Advocate of Liberty |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | September 11th 05 05:25 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | August 26th 05 05:30 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | June 8th 05 05:28 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | May 24th 05 05:27 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 3 | February 18th 05 05:34 AM |