If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
K-frame mounts
Hi!
I apologize up front for this!! This is not a jeep question, but a dodge question. You guys have been very helpful in the past with jeep problems.... In addition to 2 jeeps, I also have a '96 intrepid. It seems the k-frame mounts are giving up again. I paid the dealership a lot to replace them several years ago, but it seems I have had a return of the same grinding noise when steering, plus I just looked at some material coming out of one of the mounts. Are they hard to replace? Are there any good resources online? Any special tools required? I understand the use of rubber to deaden sound/vibrations etc, but when it starts giving up..sure is aggravating. thanks cal |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
frame & body swaps | andrew | VW air cooled | 0 | April 11th 05 09:03 PM |
Tranny Mounts Anyone? | TerryB | VW air cooled | 0 | March 14th 05 02:59 AM |
dented frame rail - problem? | pws | Mazda | 1 | October 24th 04 03:43 AM |
Frame vs Sub- Frame? thanks | [email protected] | Antique cars | 0 | August 19th 04 02:14 PM |
twistec or OEM motor mounts? | marx404 | Saturn | 11 | June 30th 04 03:47 PM |