|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 2nd 04, 06:58 PM
|
|||
|
|||
Caprice body part name?
On my 83 Caprice between the rear bumper and fender the molding flap
on each side has deteriorated. I'd like to replace, but don't know the name of this part. It's plastic and flexible, less than a foot tall and wide, and shaped to fill the gap between the rear bumper and the rear fender. I've searched for info, but without a name it's tough. What's the name of these flaps? Suggestions on where to buy one? 
|
| Ads |
|
#2
November 2nd 04, 09:29 PM
|
|||
|
|||
|
I believe they are called "fender extensions." heck11 > wrote in article >.. . > On my 83 Caprice between the rear bumper and fender the molding flap > on each side has deteriorated. I'd like to replace, but don't know > the name of this part. It's plastic and flexible, less than a foot > tall and wide, and shaped to fill the gap between the rear bumper and > the rear fender. I've searched for info, but without a name it's > tough. > > What's the name of these flaps? Suggestions on where to buy one? >
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 7 | February 1st 05 01:43 PM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 1st 04 05:24 AM |
Linear Mode
