|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 13th 09, 08:14 PM
posted to rec.autos.makers.ford.explorer
|
|||
|
|||
Front Halfshaft
Hi folks,
I have a 98 Mountaineer, 5.0, AWD with 115, 000 miles on it. I have noticed tell tale grease splotches on the right front wheel well that is aligned with the outboard CV joint. The outboard boot still looks good to a quick visual inspection, however, that is the only place the grease can be coming from as far as I can tell. Now my question to you folks: How many hours, days should a novice allow for replacing the axle? Once again, thanks for the help. Steve 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CV Boot/Halfshaft question | Dan[_13_] | Technology | 2 | October 17th 06 12:08 PM |
| 86 Golf,Halfshaft. Wheres the big washer go. | none2u | VW water cooled | 6 | February 13th 06 09:43 AM |
| Replace CV Joint or Halfshaft? | Bryan K. Walton | VW water cooled | 12 | January 27th 06 06:03 AM |
| Halfshaft - here's how I do it. | Lhead | Chrysler | 0 | May 11th 05 07:50 PM |
| CV Halfshaft color codes? | [email protected] | Honda | 2 | March 5th 05 07:04 PM |
Linear Mode
