A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers » VW air cooled
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

help to turbo



 
 
Thread Tools Display Modes
  #1  
Old December 18th 04, 09:52 AM
jex
external usenet poster
 
Posts: n/a
Default help to turbo

i am looking in to trying to put a turbo on to my 1776 beetle.
it got (044 heads big valvs polished and ported, twin 40 webers,
1.25:1 rockers, balanced crack to 5k, breather kit, 120 cam, cromoly
pushrods and lightend cam followers.)
and was thinking of trying to get the turbo from the wreckers. but
what car shal i get one off?
the engine had a deep sump and an external oil cooler but will it over
heat if it runs right?
can i still use the twin weber set up or will it be to hard? am i best
to try and only use one?
is it best to have to turbo blowing or sucking? witch is easyest?
witch is best?
will i be hard to set the card/cards up (mixture and tickover)?
were do you get an oil feed from?
has any one got and photos so i could get a better idear of the hole
set up?
and last what sort of power can i look at geting but keeping it
reliabel (it will do the 1/4 in 16sec at the min).
ps sorry about the spelling
Ads
  #2  
Old December 18th 04, 06:35 PM
Wolfgang
external usenet poster
 
Posts: n/a
Default

Do you have the book for VWs call Turbomania by Bob Thomlinson?

"jex" > wrote in message
...
>i am looking in to trying to put a turbo on to my 1776 beetle.
> it got (044 heads big valvs polished and ported, twin 40 webers,
> 1.25:1 rockers, balanced crack to 5k, breather kit, 120 cam, cromoly
> pushrods and lightend cam followers.)
> and was thinking of trying to get the turbo from the wreckers. but
> what car shal i get one off?
> the engine had a deep sump and an external oil cooler but will it over
> heat if it runs right?
> can i still use the twin weber set up or will it be to hard? am i best
> to try and only use one?
> is it best to have to turbo blowing or sucking? witch is easyest?
> witch is best?
> will i be hard to set the card/cards up (mixture and tickover)?
> were do you get an oil feed from?
> has any one got and photos so i could get a better idear of the hole
> set up?
> and last what sort of power can i look at geting but keeping it
> reliabel (it will do the 1/4 in 16sec at the min).
> ps sorry about the spelling



  #3  
Old December 18th 04, 06:42 PM
VdubBeetle1972
external usenet poster
 
Posts: n/a
Default

Good book to read but I recommend buying a kit either a cb performance or fro
aj simms at lowbugget.com If your not to comfortable or not sure on a lot of
things the time you spend messing with it will be the time you spending driving
it. To me thats money in my pocket. im going with the kit from aj on a 2276.


Jeremie
1972 SB
http://members.aol.com/vdubbeetle1972/main.html
  #4  
Old December 19th 04, 02:57 AM
ThaDriver
external usenet poster
 
Posts: n/a
Default

You'll need a very small turbo otherwise it will take too high an RPM to
produce much boost.
A draw-through system is easiest, & you would use only one carb that way.
If you do a blow-through system you'd be better off using fuel a injector
system.
You'll need a wastegate, & will have to do alot of fabrication. Check with
the major turbo manufacturers (Rajay, etc.) to see what components are
available.
A good oil source would be an aftermarket oil pump with a side fitting.
On average you'll get a 50% HP increase at around 4 or 5 lbs. boost. If
you go over that you'll need a *really* tight bottom end & other mods.
HTH,
~ Paul
aka "Tha Driver"

Giggle Cream - it makes dessert *funny*!


  #5  
Old December 20th 04, 04:12 AM
Freddy Badgett
external usenet poster
 
Posts: n/a
Default


It takes a lot to get a turbo tuned correctly. Buy all the books.. My
son races the "Hyper Bug" in the SEVWA circuit,he runs a 1641 cc with
counterweighted crank,stock rods and Mahle pistons/cyls.It is a blow
thru,with a single 48 carb. His car has run 6.83 at 101 in the 1/8 mile.
This combo has over 100 passes on it, and the internals looked nice when
checked last week.It leaves the line at 6000 Rpm, and passes the finish
line at 7500 rpm.It should, by all thats reasonable blown up a long time
ago, but it hasn't.

Freddy

 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Driving a Volvo Cross-Country 2.5 turbo in a big city florin Driving 14 December 16th 04 07:09 PM
88 Lebaron GTS 2.2L Turbo hissing noise Ken Chrysler 6 October 26th 04 01:16 AM
GT JTD Turbo lag? Grahame Alfa Romeo 10 October 20th 04 07:59 PM
problem with Audi a4 1.8t 1997 turbo - do i need a new one? G Audi 0 May 22nd 04 02:35 PM


All times are GMT +1. The time now is 12:21 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.