If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
car makes clicking noise when turning sharp! is that DANGEROUS
I have a old 1991 MAZDA 323 98K mileage and it always runs well.
But when I turn around or do a sharp turn I get the old click! click! click! clicking noise Ive been told its just the joints/ Suspension....but is it DANGEROUS to drive?. Its been clicking now for two years. |
Ads |
#2
|
|||
|
|||
> wrote in message oups.com... > I have a old 1991 MAZDA 323 98K mileage and it always runs well. > But when I turn around or do a sharp turn I get the old click! click! > click! clicking noise Ive been told its just the joints/ > Suspension....but is it DANGEROUS to drive?. > > Its been clicking now for two years. It is most likely one or both CV joints. Brakes can do it, but the CV joints are most likely. If one of them should break while you are moving at highway or freeway speed, it could be dangerous. |
#3
|
|||
|
|||
|
#4
|
|||
|
|||
It is not dangerous to drive until it is worn enough to make noise when going straight. wrote: > > I have a old 1991 MAZDA 323 98K mileage and it always runs well. > But when I turn around or do a sharp turn I get the old click! click! > click! clicking noise Ive been told its just the joints/ > Suspension....but is it DANGEROUS to drive?. > > Its been clicking now for two years. -- Mike Walsh West Palm Beach, Florida, U.S.A. |
#5
|
|||
|
|||
"Mike Walsh" > wrote in message ... > > It is not dangerous to drive until it is worn enough to make noise when going straight. > Just don't go on any long trips. :-) If you do your own work a CV joint is usually pretty easy - you just pull out the axle on that side and take it to your local parts place and get a rebuilt unit. Ted |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | May 8th 05 05:29 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
Steering column grinding / squeaking noise when turning right | Ed Jones | VW air cooled | 2 | January 2nd 05 10:45 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | January 2nd 05 05:15 AM |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |