If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Filling coolant system 2000 intrepid
Is there anything special that needs to be done when refilling the cooling
system on a 2000 Intrepid with a 2.7Liter? The only place to put the fluid is in the overflow tank |
Ads |
#2
|
|||
|
|||
With my 1997 Intrepid. you must remove the air from the lines while filling
coolant to proper level.There's a bleed valve right in front of the engine,at the end of the upper radiator hose where it connects to the thermostat housing. Loosen it untill there's a little flow coming -out bubble free.. (while engine is running). After that tightened the bleed valve. Good to go! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LIDAR Trial this Week | [email protected] | Driving | 17 | April 9th 06 02:44 AM |
Flush Radiator - Opinions | Richard | Saturn | 7 | April 4th 05 04:59 PM |
2000 Accord coolant drain plug location | Howard and Audrey | Honda | 0 | December 21st 04 05:01 PM |
Coolant system flushin 96 A4 | Iain Miller | Audi | 0 | December 10th 04 01:32 PM |
Broken driver window system A6 2000 (repost) | Josh | Audi | 2 | September 28th 04 11:10 PM |