If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HELP
This is the deal. I had the emergency brake on on my truck because my
driveway has a slant to it. I went to go and leave so I released the emergency brake and then turned my car on. I then put the car in reverse so that I could leave. The truck wouldn't move. I tried it in drive. The truck wouldn't move. I put it in neutral and it still wouldn't go anywhere. The speedomoter wouldn't even move. What do I do? I need answers quick. |
Ads |
#2
|
|||
|
|||
HELP
Well, if you need answers quick, perhaps you can provide some details: what
kind of truck it is, year, mileage, engine size, automatic or manual, 2 or 4 wheel drive? You know, the basics... "bigwaverider" > wrote in message lkaboutautos.com... > The speedomoter wouldn't even move. What do I do? I need answer quick. |
#3
|
|||
|
|||
HELP
"bigwaverider" > wrote in message lkaboutautos.com... > This is the deal. I had the emergency brake on on my truck because my > driveway has a slant to it. I went to go and leave so I released the > emergency brake and then turned my car on. I then put the car in reverse > so that I could leave. The truck wouldn't move. I tried it in drive. The > truck wouldn't move. I put it in neutral and it still wouldn't go > anywhere. The speedomoter wouldn't even move. What do I do? I need answers > quick. > If it's an automatic transmission I'd try pushing it forward a little. The trans may have locked up. I always put mine in gear before releasing the parking brake. |
#4
|
|||
|
|||
HELP
Sounds as if your emergency brake cable is rusted and frozen in place. Try a little diesel fuel, WD40 or any other type of low visc solvent on your cables, one on each side connected to the backing plate of the rear brake. Apply than reapply your parking brake tell they are free. If this fails you may have to remove the rear wheels, not 100% necessary, than use vice grips or what ever works to free up your rusted cables. At some point you will need to replace those rusted cables. Good luck, Ron bigwaverider wrote: > This is the deal. I had the emergency brake on on my truck because my > driveway has a slant to it. I went to go and leave so I released the > emergency brake and then turned my car on. I then put the car in reverse > so that I could leave. The truck wouldn't move. I tried it in drive. The > truck wouldn't move. I put it in neutral and it still wouldn't go > anywhere. The speedomoter wouldn't even move. What do I do? I need answers > quick. > |
#5
|
|||
|
|||
HELP
Good advice, but be VERY careful if you jack the truck up on a steep
driveway. Make sure all wheels that remain on the ground are securely chocked with wooden blocks or similar. Try not to lift both back wheels at the same time, Seems obvious I know, but it has been known for experienced home mechanics to overlook the fact that the handbrake will not be effective if both rear wheels are off the ground Trefor "Ron & Maggie" > wrote in message .. . > > Sounds as if your emergency brake cable is rusted and frozen in place. Try > a little diesel fuel, WD40 or any other type of low visc solvent on your > cables, one on each side connected to the backing plate of the rear brake. > Apply than reapply your parking brake tell they are free. If this fails > you may have to remove the rear wheels, not 100% necessary, than use vice > grips or what ever works to free up your rusted cables. At some point you > will need to replace those rusted cables. > > Good luck, > > > Ron > |
#6
|
|||
|
|||
HELP
"Trefor" > wrote in message ... > Good advice, but be VERY careful if you jack the truck up on a steep > driveway. > Make sure all wheels that remain on the ground are securely chocked with > wooden blocks or similar. > Try not to lift both back wheels at the same time, Seems obvious I know, > but it has been known for experienced home mechanics to overlook the fact > that the handbrake will not be effective if both rear wheels are off the > ground > > Trefor > > > "Ron & Maggie" > wrote in message > .. . >> >> Sounds as if your emergency brake cable is rusted and frozen in place. >> Try a little diesel fuel, WD40 or any other type of low visc solvent on >> your cables, one on each side connected to the backing plate of the rear >> brake. Apply than reapply your parking brake tell they are free. If this >> fails you may have to remove the rear wheels, not 100% necessary, than >> use vice grips or what ever works to free up your rusted cables. At some >> point you will need to replace those rusted cables. >> >> Good luck, >> >> >> Ron >> > > This would have been good info two days ago when he posted in a big hurry. The guys probably dead by now. Trapped under his own back wheels in his nice steep driveway. LOL |
#7
|
|||
|
|||
HELP
I bet you're a riot at parties Darby ROFL Trefor > This would have been good info two days ago when he posted in a big hurry. > The guys probably dead by now. Trapped under his own back wheels in his > nice steep driveway. LOL > |
Thread Tools | |
Display Modes | |
|
|