If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Off Road!
I finally took Clementine offroad! Really fun! Hubby made
me put her in 4L but it was a 4H trail. Made one heck of a noise going into gear...that was the scaryest part! I sure like the short wheel base for going over steep thingies:^) I'm disappointed tho, the Amber Fire color doesn't show mud! Seahag |
Ads |
#2
|
|||
|
|||
The LO Range gears are not syncronized, so you should be moving slowly, walking speed is usually good, when going into 4LO. Coming out of 4LO into 4HI is a bit easier and can be done <carefully> without stopping, but the gears will still grind. Usually, you'll be tooling along in 4HI and get stuck on a rock or something, and for any number of reasons you might decide to use 4LO, but because you are now stopped you may find that the gears collide and the shifter won't move into 4LO very easily. If this happens, you can let the clutch out so the gears turn a bit, then push the clutch back in as you pull the lever into 4LO. The vehicle may jump a bit, so be sure there isn't anybody standing near the tires. Once you get 4LO selected, then you can proceed in the apporpriate manner. "Seahag" > wrote in message ... > I finally took Clementine offroad! Really fun! Hubby made > me put her in 4L but it was a 4H trail. Made one heck of a > noise going into gear...that was the scaryest part! I sure > like the short wheel base for going over steep thingies:^) > I'm disappointed tho, the Amber Fire color doesn't show mud! > > Seahag > > |
#3
|
|||
|
|||
I was trying to go dead slow, the manual sez 2 to 3 mph, but
I guess I was going too fast. Seahag "Steve" > wrote: > That scary sound is the transfer case telling you to come > to a near stop before dropping to low. Damage! I find mine > goes into low best when at a dead stop with the > transmission in neutral. > > Seahag wrote: >> Hubby made me put her in 4L but it was a 4H trail. Made >> one heck of a noise going into gear...that was the >> scaryest part! |
#4
|
|||
|
|||
"Jeff Strickland" > wrote: > > The LO Range gears are not syncronized, so you should be > moving slowly, > walking speed is usually good, when going into 4LO. Coming > out of 4LO into > 4HI is a bit easier and can be done <carefully> without > stopping, but the > gears will still grind. > > Usually, you'll be tooling along in 4HI and get stuck on a > rock or > something, and for any number of reasons you might decide > to use 4LO, but > because you are now stopped you may find that the gears > collide and the > shifter won't move into 4LO very easily. If this happens, > you can let the > clutch out so the gears turn a bit, then push the clutch > back in as you pull > the lever into 4LO. The vehicle may jump a bit, so be sure > there isn't > anybody standing near the tires. Once you get 4LO > selected, then you can > proceed in the apporpriate manner. I think part of my problem was that the manual mentioned something about not stopping in Neurtal while you shift to 4LO. So I just kinda grabbed the handle and went for it! It didn't grind badly, just surprised me not having done it before. Thanks for the tips, just wish it was something I could practice! Seems there are very few ORV trails in Maryland. Seahag |
#5
|
|||
|
|||
"Seahag" > wrote in message ... > > "Jeff Strickland" > wrote: > > > > The LO Range gears are not syncronized, so you should be > > moving slowly, > > walking speed is usually good, when going into 4LO. Coming > > out of 4LO into > > 4HI is a bit easier and can be done <carefully> without > > stopping, but the > > gears will still grind. > > > > Usually, you'll be tooling along in 4HI and get stuck on a > > rock or > > something, and for any number of reasons you might decide > > to use 4LO, but > > because you are now stopped you may find that the gears > > collide and the > > shifter won't move into 4LO very easily. If this happens, > > you can let the > > clutch out so the gears turn a bit, then push the clutch > > back in as you pull > > the lever into 4LO. The vehicle may jump a bit, so be sure > > there isn't > > anybody standing near the tires. Once you get 4LO > > selected, then you can > > proceed in the apporpriate manner. > > I think part of my problem was that the manual mentioned > something about not stopping in Neurtal while you shift to > 4LO. So I just kinda grabbed the handle and went for it! > It didn't grind badly, just surprised me not having done it > before. Thanks for the tips, just wish it was something I > could practice! Seems there are very few ORV trails in > Maryland. > The reason you don't want to stop is because the gears grind. The gears grind because there are no synch rings, and because there are no synch rings AND the gears are relatively fat, they can strike on edge if they are not moving. You won't hurt anything if you shift into LO while at a standing stop, but if the gears strike each other on edge and the lever won't physically move into position. The recovery from this is to let the clutch out partially while moving the lever at the same time, the gears will move out of each other's way, and the lever will slip into position. I have found that I need to do this while the transmission is in gear, not Neutral. If you are moving when you shift into LO, then the gears will also slip into position, but they will grind first. |
#6
|
|||
|
|||
Real Jeepers with sticks, double clutch the transfer neutral
position, just like the Real truckers, shift their dual-stick Brownie auxiliary transmissions. God Bless America, ßill O|||||||O http://www.billhughes.com/ Jeff Strickland wrote: > > The reason you don't want to stop is because the gears grind. > > The gears grind because there are no synch rings, and because there are no > synch rings AND the gears are relatively fat, they can strike on edge if > they are not moving. You won't hurt anything if you shift into LO while at a > standing stop, but if the gears strike each other on edge and the lever > won't physically move into position. The recovery from this is to let the > clutch out partially while moving the lever at the same time, the gears will > move out of each other's way, and the lever will slip into position. I have > found that I need to do this while the transmission is in gear, not Neutral. > If you are moving when you shift into LO, then the gears will also slip into > position, but they will grind first. |
#7
|
|||
|
|||
Oh no! Not "real Jeepers"! ;^)
Seahag "L.W. ("ßill") Hughes III" > wrote in message ... > Real Jeepers with sticks, double clutch the transfer > neutral > position, just like the Real truckers, shift their > dual-stick Brownie > auxiliary transmissions. > God Bless America, ßill O|||||||O > http://www.billhughes.com/ > > Jeff Strickland wrote: >> >> The reason you don't want to stop is because the gears >> grind. >> >> The gears grind because there are no synch rings, and >> because there are no >> synch rings AND the gears are relatively fat, they can >> strike on edge if >> they are not moving. You won't hurt anything if you shift >> into LO while at a >> standing stop, but if the gears strike each other on edge >> and the lever >> won't physically move into position. The recovery from >> this is to let the >> clutch out partially while moving the lever at the same >> time, the gears will >> move out of each other's way, and the lever will slip >> into position. I have >> found that I need to do this while the transmission is in >> gear, not Neutral. >> If you are moving when you shift into LO, then the gears >> will also slip into >> position, but they will grind first. |
#8
|
|||
|
|||
"Jeff Strickland" > wrote: > > "Seahag" > wrote: >> >> "Jeff Strickland" > wrote: >> > >> > The LO Range gears are not syncronized, so you should >> > be >> > moving slowly, >> > walking speed is usually good, when going into 4LO. >> > Coming >> > out of 4LO into >> > 4HI is a bit easier and can be done <carefully> without >> > stopping, but the >> > gears will still grind. >> > >> > Usually, you'll be tooling along in 4HI and get stuck >> > on a >> > rock or >> > something, and for any number of reasons you might >> > decide >> > to use 4LO, but >> > because you are now stopped you may find that the gears >> > collide and the >> > shifter won't move into 4LO very easily. If this >> > happens, >> > you can let the >> > clutch out so the gears turn a bit, then push the >> > clutch >> > back in as you pull >> > the lever into 4LO. The vehicle may jump a bit, so be >> > sure >> > there isn't >> > anybody standing near the tires. Once you get 4LO >> > selected, then you can >> > proceed in the apporpriate manner. >> >> I think part of my problem was that the manual mentioned >> something about not stopping in Neurtal while you shift >> to >> 4LO. So I just kinda grabbed the handle and went for it! >> It didn't grind badly, just surprised me not having done >> it >> before. Thanks for the tips, just wish it was something >> I >> could practice! Seems there are very few ORV trails in >> Maryland. >> > > The reason you don't want to stop is because the gears > grind. > > The gears grind because there are no synch rings, and > because there are no > synch rings AND the gears are relatively fat, they can > strike on edge if > they are not moving. You won't hurt anything if you shift > into LO while at a > standing stop, but if the gears strike each other on edge > and the lever > won't physically move into position. The recovery from > this is to let the > clutch out partially while moving the lever at the same > time, the gears will > move out of each other's way, and the lever will slip into > position. I have > found that I need to do this while the transmission is in > gear, not Neutral. > If you are moving when you shift into LO, then the gears > will also slip into > position, but they will grind first. Thanks, that clears up some of the mystery! Seahag |
#9
|
|||
|
|||
I think you have me figured out. :-)
God Bless America, ßill O|||||||O http://www.billhughes.com/ Seahag wrote: > > Oh no! Not "real Jeepers"! ;^) > > Seahag |
#10
|
|||
|
|||
It was a nasty job, but someone had to do it!
Seahag "L.W. ("ßill") Hughes III" > wrote: > I think you have me figured out. :-) > God Bless America, ßill O|||||||O > http://www.billhughes.com/ > > Seahag wrote: >> >> Oh no! Not "real Jeepers"! ;^) >> |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
"Black box" in cars to log toll road use in Britain coming | [email protected] | Driving | 1 | June 6th 05 10:33 PM |
Road recordings for Kerouac Project | [email protected] | Driving | 0 | April 1st 05 09:58 AM |
Is it legal to hit other cars on the road? | Universal Soldier | Driving | 51 | February 26th 05 09:39 PM |
drive with kindness (road peace instead of road rage) | dash2 | Driving | 42 | January 6th 05 08:32 PM |
Audi All Road reliability | LIW | Audi | 2 | November 3rd 04 08:39 PM |