If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Radius Arm Bushings---Need Advice
I recently changed the bushings on my '93 explorer with Dealer parts
and now the clunking when I brake is worse than ever. I'm wondering if I could have put the nylon spacers on the wrong way around. The ones I replaced had the cup facing the nuts so I put the new ones on that way but it looked as if the cup side should really be facing the front of the truck. Does anyone know which way they should be facing and/or any other reasons why I would still be getting the noise? TIA... J.D. |
Ads |
#2
|
|||
|
|||
Radius Arm Bushings---Need Advice
On 4 Sep 2006 18:11:25 -0700, "J.D." > wrote:
>I recently changed the bushings on my '93 explorer with Dealer parts >and now the clunking when I brake is worse than ever. > >I'm wondering if I could have put the nylon spacers on the wrong way >around. The ones I replaced had the cup facing the nuts so I put the >new ones on that way but it looked as if the cup side should really be >facing the front of the truck. > >Does anyone know which way they should be facing and/or any other >reasons why I would still be getting the noise? > >TIA... J.D. It's been a while since I did mine but I seem to recall that the dealer parts did not include all the parts, like one of the big washers or something. Sorry I can't recall more but it does seem like when I put it together it needed another washer to really snug up tight. I also replaced one side of the cross brace it mounts to because the hole in it was a little worn looking. The whole thing is a ****-poor design. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1st Gen (1988) Legend radius arm & bushings | Ryan Biggs | Honda | 1 | July 26th 06 02:17 AM |
Urethane Bushings Where? and Replace Quad Shocks? | [email protected] | Ford Mustang | 4 | October 27th 05 04:00 PM |
Strut rod failure due to polyurethane bushings | Evan | Ford Mustang | 6 | June 4th 05 09:00 PM |
Radius Arm Bushings FYI | AZGuy | Ford Explorer | 0 | December 22nd 04 07:03 PM |
Alignment Advice | Chopface | Honda | 2 | November 6th 04 04:28 AM |