If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Acura TL caliper bolts?
I have a 2002 Acura TL -S, and want to install new front
rotors/pads...somebody mentioned the caliper bolts would be the same as an Accord. I don't know if that is true, but what I am after is the bolt type/size, to make sure I have the right tools before jacking here up. Any help? TIA! |
Ads |
#2
|
|||
|
|||
Acura TL caliper bolts?
On Thu, 16 Nov 2006 08:45:30 -0500, Netsock > wrote:
>I have a 2002 Acura TL -S, and want to install new front >rotors/pads...somebody mentioned the caliper bolts would be the same >as an Accord. >I don't know if that is true, but what I am after is the bolt >type/size, to make sure I have the right tools before jacking here up. There's nothing special about the bolts. If you have a typical metric socket set, it'll have a socket that'll fit. |
#3
|
|||
|
|||
Acura TL caliper bolts?
On Thu, 16 Nov 2006 17:06:25 GMT, AZ Nomad
> wrote: >There's nothing special about the bolts. If you have a typical metric >socket set, it'll have a socket that'll fit. Thanks AZ! Just wanted to make sure it wasn't a torx, allen, or 12 point. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Strength of Impact Wrench to Remove Caliper Bracket Bolts? | jim | Technology | 8 | August 19th 05 03:38 AM |
2002 T$C caliper bolts | sweenerman | Chrysler | 1 | August 13th 05 07:17 AM |
1992 Honda Accord brakes drag if caliper bolts (over) ?? tightned | Mark | Technology | 5 | July 7th 05 10:29 PM |
97 Jetta GT rear brake caliper bracket bolts stripping | Chad Leigh | VW water cooled | 4 | October 8th 04 03:48 AM |
Socket For Loosening Caliper Bolts On 2000 Audi A4? | Don Christine | Audi | 3 | August 31st 04 11:22 PM |