If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Does a 36 IDF fit on a 40 IDF manifold ?
And are airfilter baseplates interchangeable. |
Ads |
#2
|
|||
|
|||
the 36/40/44/48 Weber IDF, and 36/40/45/48mm Dellorto DRLA share the same
bolt pattern. However, putting a huge carb on a small intake will result in the throttle plate hitting the insides of the intake opening, and putting a small carb on a huge intake will result in intake turbulence (which most people would never notice). There ARE intakes that are specifically sized for the carb size you intend on using, but most people do not know this. John Aircooled.Net Inc. "Craig Baker" > wrote in message ... > > And are airfilter baseplates interchangeable. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Low Manifold Vacuum | Rich Hampel | Jeep | 12 | January 19th 05 03:16 AM |
91 Accord LX 2.2L exhaust manifold cracked | Arthur Russell | Honda | 1 | December 19th 04 04:08 AM |
Exhaust Manifold / Header question (1996 Accord EX) | Chip Stein | Honda | 0 | September 22nd 04 02:23 AM |
Intake Manifold Recommendation - Torker? | [email protected] | Corvette | 7 | August 25th 04 06:07 PM |