If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2000 Mustang Convertible sticking
HI Everyone,
My 2000 mustang convertible is now sticking. It worked fine on Saturday. The driver side does not want to come up. I can hear the motor trying to click, but not working. How much does it normally cost to fix the convertible top motor? This is my second mustang convertible and this has not happened before. thanks NC |
Ads |
#2
|
|||
|
|||
"southernbell1990" > wrote in message lkaboutautos.com... > HI Everyone, > My 2000 mustang convertible is now sticking. It worked fine on Saturday. > The driver side does not want to come up. I can hear the motor trying to > click, but not working. But the passenger side is trying to rise? Seems that it is the driver side hydraulics that are failing. Could be as simple as hydraulic line that has come free/loose. Suggest that you remove the rear seat and look before running the pump again. -- Richard '94 GT 'vert Under Drive Pulleys Transgo HD2 Reprogramming Kit High Stall Torque Converter 4:10 Gears Gripp Sub Frame Connectors (welded) FRPP Aluminum Drive shaft FRPP M5400-A Suspension Laser Red |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mustang Returns to Sports Car Racing | Grover C. McCoury III | Ford Mustang | 0 | January 29th 05 05:39 PM |
21st Century Goat vs Mustang Shootout | [email protected] | Ford Mustang | 1 | January 15th 05 06:09 PM |
Ford to Unveil Latest Convertible Mustang | Grover C. McCoury III | Ford Mustang | 4 | January 6th 05 03:54 PM |
Mustang Fever All Over Again | Jim S. | Ford Mustang | 12 | December 13th 04 09:11 PM |
2000 Mustang Convertible Top Alignment | [email protected] | Ford Mustang | 2 | December 13th 04 03:04 PM |