|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 4th 05, 06:46 PM
|
|||
|
|||
fluid capacity of GM 9.5" rear axle
I'm overhauling a GM 9.5" semi-floating rear end prior to installing it and
I want to add the fluid before I put it in. Anyone know the correct amount? I don't want to use the fill to the filler hole method since it's on stands and not level, plus it's a lot easier to just dump the fluid in the back and slap on the cover... Thanks, Brian 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1994 E36 Vibration in rear axle? | Lordy | BMW | 7 | February 4th 05 03:35 AM |
| New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
| Rear axle bushing - rubber or poly? | Andrew Hall | VW water cooled | 2 | November 16th 04 12:10 PM |
Linear Mode
