If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can a intake that has emissions be pulled off with a better one?
I have a 302 that has been bored .30 over. (this is the same motor that I
have listed before but it seemed like a different thread question.) And if I take all the emissions stuff like intake and smug pump and leave it off but I replace it will headers edelbrock intake and 4 barrel carb will there be anything in the engine that won't work right after that? This is going into a '66 stang that currently has a straight 6. Thanks for your help. |
Ads |
#2
|
|||
|
|||
D.L. Man wrote:
> If I > take all the emissions stuff like intake and smug pump and leave it off but > I replace it will headers edelbrock intake and 4 barrel carb will there be > anything in the engine that won't work right after that? "Smug pump." I like it. Answer to question: generally no. 180 Out |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Update on Arizona Emissions Bill! | Laurie S. | Ford Mustang | 3 | March 11th 05 06:32 PM |
intake or head gasket bad...need opinion... | scale | Technology | 4 | February 20th 05 10:02 PM |
California Emissions for 2000 Ford(49state) HELP! | TheSmogTech | Technology | 0 | January 31st 05 11:23 PM |
Arizona Emissions Alert - Important!!! | Laurie S. | Ford Mustang | 0 | January 18th 05 09:38 PM |
Drive Clean, old A2s, and NOx emissions | Garry Tarr | VW water cooled | 1 | November 9th 04 12:18 PM |