If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Should driveshaft turn at all (by hand)
I'm trying to assess the condition of my 93's U joints. I got under
the car and tried to turn the driveshaft by hand. I could turn it a little bit, I would say about 1/4" of travel measured at the surface of the shaft. Should I be able to turn it at all by hand? Thanks, John V |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TURN $6 INTO $15,000 IN ONLY 30 DAYS. | Kelly Silva | Dodge | 0 | April 14th 06 11:19 AM |
bad turn signal | [email protected] | Technology | 1 | October 3rd 05 03:54 PM |
Neon - rapidly blinking turn signal - diagnosis? | Neon96 | Dodge | 2 | August 21st 05 02:10 AM |