If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Allen Wrench size for tranny
fixing to have to run to San Antonio to get parts, Can someone tell me
what size the drain plug Allen wrench size is. Hopefully someone will reply back befor i go. tony |
Ads |
#2
|
|||
|
|||
17mm IIRC
"tonks" > wrote in message ups.com... > fixing to have to run to San Antonio to get parts, Can someone tell me > what size the drain plug Allen wrench size is. Hopefully someone will > reply back befor i go. tony > |
#3
|
|||
|
|||
Thanks for the reply, sure helpfull. Tony
|
#4
|
|||
|
|||
17mm.
i bought one from Sears BTW Tony that will fit the inside allen bolt in the rear trailing arm of that IRS '69. look at the thing next time you are under there. but the edges are kind of "peened" to keep it from backing out i ended up just whacking it with a hammer to get the bolt out. -- ************************************************** ************** dragenwagen 1966 Type I - Daily Driver 1969 Type I - Undergoing heater channel replacement http://www.ramva.org/dragenwagen "Old VW's Don't Leak Oil, They Mark Their Territory." ************************************************** ************** "tonks" > wrote in message ups.com... > fixing to have to run to San Antonio to get parts, Can someone tell me > what size the drain plug Allen wrench size is. Hopefully someone will > reply back befor i go. tony > |
#5
|
|||
|
|||
> ************************************************** ************** > dragenwagen > 1966 Type I - Daily Driver > 1969 Type I - Undergoing heater channel replacement > http://www.ramva.org/dragenwagen > "Old VW's Don't Leak Oil, They Mark Their Territory." > ************************************************** ************** I thought you had finished the heater channel replacement? Or have you had to replace the channels in both VW's? Just curious. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
good tires in "non-performance" size? | Daniel J. Stern | Driving | 8 | February 15th 05 09:16 PM |
Torque Wrench | Seraph | Honda | 12 | February 6th 05 10:07 PM |
Is Impact Wrench Proper Tool? | Ron | Technology | 13 | January 21st 05 12:58 AM |
1998 Honda Accord 4-cyl Allen Head Bolt Under Oil Filter - what is it? | amp11plzDontSpam | Honda | 0 | January 17th 05 09:26 AM |
torque wrench calibration | [email protected] | Technology | 7 | December 20th 04 05:47 PM |