|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 17th 09, 03:45 AM
posted to rec.autos.makers.mazda.miata
|
|||
|
|||
j & s safe guard / knock sensor
hi,
is there any way to test my j & s safe guard box and knock sensor? also, many moons ago, leon sent me an air/fuel mixture read out meter but i do not have the "extender harness" so i am not sure which wire on the 2 wire plug on the meter is the fround and which one goes to the O2 sensor. any hints? does it matter? can i just try one and i wont damage any thing? oh btw it there a good way to torque the crank pulley bolt w/o the special tool and with only one person? tia, peter 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| knock sensor | tmg6464 | Technology | 1 | November 24th 07 02:58 PM |
| Knock Sensor | Linda[_2_] | Saturn | 0 | April 14th 07 12:34 AM |
| camshaft positon sensor A bank 1/ verses knock sensor | vita via CarKB.com | Saturn | 5 | June 21st 06 06:57 PM |
| AWA [OFFER] Wheel sensor;Crankshaf position sensor;camshaft sensor;knock sensor;phase s | [email protected] | General | 0 | January 10th 06 12:51 PM |
| About that knock sensor... | Philip Nasadowski | Saturn | 7 | October 13th 04 07:55 PM |
Linear Mode
