If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#4
|
|||
|
|||
We used a buiseness card to check the seals and found no anomolies. We even
compared the spacing with another SC2, no obvious difference. We tried putting tape over the outside of the door where the outside door seals meet the window by the applique, it seemed to quell the wind noise when taping up the top of the door. So - based upon that, we are guessing that the door frame MAY have been inadvertantly bent when the Ventshade was pulled off. gee Dan, the only song I can think of that would even remotely disquise the noise would be Pink Floyd's "A Pillar of Winds", er-thanks anywayz...... What do you think blah blah, door frame bent, seal destroyed, what could it be? I am going crazy from the noise. marx404 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | January 2nd 05 06:15 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 06:15 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 06:19 AM |
Convertable wind noise | yar | Corvette | 4 | October 7th 04 05:21 PM |