Need info. GM 3.4 ltr engine Pontiac Montana

Hi folks
I have a 1998 Pontiac Transport Montana Extended with a dead 3.4 ltr
motor (camshaft broke and bearings are finished). Dealers are saying
only 1998 chevy, olds or pontiac 3.4 van engines would fit.
Any of you have any experience with this engine? Will a 2003 Aztek 3400
fit this Montana? Camshaft sensor connector is different but both are
three wires and its possible to cut and fit, but would that work?
Or should I go for a 3.8 swap? Will that work?

Thanks in advance.

You would need the pcm and harness and probably the trans wiring is
different also. Check with a salvage for direct interchange info.
"gearshift" > wrote in message
oups.com...
> Hi folks
> I have a 1998 Pontiac Transport Montana Extended with a dead 3.4 ltr
> motor (camshaft broke and bearings are finished). Dealers are saying
> only 1998 chevy, olds or pontiac 3.4 van engines would fit.
> Any of you have any experience with this engine? Will a 2003 Aztek 3400
> fit this Montana? Camshaft sensor connector is different but both are
> three wires and its possible to cut and fit, but would that work?
> Or should I go for a 3.8 swap? Will that work?
>
> Thanks in advance.
>



----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----

you are better off getting the right motor for the van. Why in the
world would you want to try and put a 3.8L in the van?