If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1980 toyota 4x4 front rotor removal
1980 toyota 4x4 truck 4cyl 20r eng.I have the Hub off,brake caliper is
off,repair manuals don't show my truck rotor brake down ,so what would i do next, To remove the rotor . any help would be grate!! |
Ads |
#2
|
|||
|
|||
1980 toyota 4x4 front rotor removal
On the 85' model, you have to take off the wheel studs to get the rotor off.
The wheel studs have to be pressed out, or use a nut to protect the threads while pounding on it. Never done it, but sounds like a bitch. Ben "80toyota4x4" > wrote in message lkaboutautos.com... > 1980 toyota 4x4 truck 4cyl 20r eng.I have the Hub off,brake caliper is > off,repair manuals don't show my truck rotor brake down ,so what would i > do next, To remove the rotor . any help would be grate!! > |
#3
|
|||
|
|||
1980 toyota 4x4 front rotor removal
I believe Ben is wrong, you must be talking about front brake rotors, Ben
is referring to the rear drums. If you have rotors, then all the Toyota's I've seen, have 2 small holes drilled near the lug nut studs, the 2 holes are opposite each other, they are threaded. You need to find the right metric bolts (2) one for each hole, then with a rachet and socket you have to tighten the bolts slowly and evenly, and if necessary pound the side of the rotor then tighten the bolts more. The bolts have to be long enough to go thru the holeand hit the backing plate, Once you hit the backing plate, the bolts will push the rotor outward as you tighten. Good luck Bob G |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
92 Explorer Front End noise | E | Ford Explorer | 3 | March 1st 06 08:58 PM |
91 Ford Explorer front end noise | [email protected] | 4x4 | 0 | February 23rd 06 04:23 PM |
General front end alignment question | James | Technology | 7 | April 9th 05 03:46 AM |
Running in low range 4wd with front hubs unlocked | Neil Klaer | 4x4 | 3 | September 20th 04 11:45 PM |