In article >,
KJB > wrote:
> When moving the throtttle plate slowly and expecting to see a change in
> the resistance across the specified terminals, the value didn't change
> at all, like I wasn't moving the throttle plate at all. Do any of you
> have knowledge about TPS to know that it is definitely bad, based on the
> results I just noted?
I *think* it's just a switch rather than pot. Can't look it up at the
moment.
> What else on the M50 would cause this poor running?
> I appreciate any help!!
I'd say the best way would be to have the codes read. This should give the
problem.
--
*Time flies like an arrow. Fruit flies like a banana.*
Dave Plowman
London SW
To e-mail, change noise into sound.