"Will Honea" > wrote in message
...
> Found my a/c leak today - dye all over the front of the compressor at
> the seam where the flat plate bolts onto the front end. I don't see
> any leak down by the shaft, but I assume that it would be just good
> practice to change the shaft seal while I'm in there. Biggest
> question I have is where to find the gasket/seal kit to rebuild this
> thing. This is an 88 MJ and I'm going the whole route from R12 to
> R134a. What compressor do I ask about if I go to someplace other than
> the dealr for the seals? Any thoughts on the cheapest place to find
> the parts and any hints on pulling the clutch off the shaft?
>
> I've got a good vacuum pump and all the scales/guages - what do I need
> to pay attention to besides the accumulator/dryer while I'm flushing
> the system before I refill?
>
> --
> Will Honea
I have used these guys
http://www.discountacparts.com/
Coasty