"Kathy and Erich Coiner" > wrote in message
news:PGVxe.7990$Fy4.267@trnddc04...
> Worst comes to worse, you can grind/ break the heads of the bolts
off the
> cylinder Then use new hardware with the new cylinder.
>
> My trick for getting tubing nuts off is this.
>
> First place a tubing wrench on the nut. Then take vise grips and
close them
> over the wrench.
> The vise grips keep the wrench from flexing open as you bust the nut
loose.
> Use big enough vise grips and you can prevent rounding off the nut.
>
> Erich
Thanks for this above tip, using a vice grip over
a tubing wrench. It happened to me once where
I rounded a tubing nut and had a heck of a time
getting it off.
This vice grip method should prevent that
from haappening.
Denny B
> "Denny B" > wrote in messag> >
>
|