you could allways strip the engine down and split the case with it in
the car !
I think that would leave you with the flywheel and crank sticking out.
might be an option .

Rich


tricky wrote:

> Second thoughts - that wouldnt shock the right bit . Ignore my
> nonsensical ramblings !
>
> Rich
>
>
> tricky wrote:
>
>> Just thinking about this option of hitting/shocking it - could you
>> send a shockwave trough the crank from the pully end ? or would that
>> be a bad thing ! ?
>>
>> Rich
>>
>>
>> Briantelope wrote:
>>
>>> In article >,
>>> Speedy Jim > wrote:
>>>
>>>
>>>> Not sure if this is physically possible, but if a thin steel
>>>> wedge could be inserted into the gap, one could push it against
>>>> the tranny shaft and then strike it with hammer blows.
>>>> The resulting shock might very well break the rust gripping
>>>> the splines on the clutch disc.
>>>
>>>
>>>
>>>
>>> yeah, I kept thinking what the best way to break the hold would be.
>>> that's a good idea, but the hard part is finding something thin
>>> enough, but strong enough. Brian
>>>