Joao Eliseu wrote:
> "Remco" > wrote:
> >P.J. Berg wrote:
> >> Remco wrote:
> >> > Hi all
> >> >
> >> > I've been thinking of a way to get the body off my bug. I know I could
> >> > just lift it off with a couple of friends and put it on sawhorses.
> >> > It is just hard to get friends together at a very specific time.
> >> > Looking at how to replace the heater channels, it looks like the body
> >> > has to be test fitted on the frame several times.
> >> > (I've never done this before also want to keep my friends in the
> >> > process
> >> >
> >> > The idea was that I have to be able to lift the body by myself at will
> >> > and be able to hover it over the pan withing 1/2 inch or so. This way
> >> > frequent alignment will be less of a pain.
> >> >
> >> > I like building fixtures so built this "body lift", built out of
> >> > dimensional lumber and will post some pictures eventually.
> >> > This is how it works:
> >> > Envision two (front and back) very strong saw horses where the cross
> >> > members can move up and down by means of two threaded rods.
> >> > Depending on the turning direction of these rods, the cross member
> >> > moves up or down.
> >> > The rear is built and ready to go. With an air wrench, the back can be
> >> > lifted up in minutes, high enough to clear the rear wheel. With two of
> >> > these contraptions (front and back) one just has to be careful to raise
> >> > each corner gradually so the body raises evenly.
> >> >
> >> > The body sits on top of this cross member, just under the spot where
> >> > the bumper mount is bolted to the body.
> >> > It'll probably be secured by chaining the cross member to the bumper
> >> > mount bolt holes for safety but it won't be supported this way.
> >> >
> >> > Is this a good spot to support the body? It looks structurally sound.
> >> > Or would it be best to bring it back down and sit it on something else?
> >> >
> >> > Thanks for any suggestions.
> >> > Remco
> >> >
> >>
> >> You can actually lift the body yourself, one end at a a time, not too
> >> heavy..
> >>
> >Thanks -- Yeah, I've tried that and it worked fine for getting it off.
> >It isn't that heavy, you're right.
> >
> >I was really interested in bringing the body down and letting it sit
> >maybe a cm above the pan. This way I can align everything properly
> >without ****ing my friends off while they are holding it up
> >
> If you have cool beer on the garage maybe it can help you friends to hold the body,
> but not on the alignment it. The other solution looks a bit complicated

Cool beer is the lubricant for many things I have a t-shirt that
says "will work for beer" and my friends have taken me up on it:
They have gotten decks and additions built, basements finised, kitchens
redone, plumbing installed and their electrical rewired by offering me
beer - Come to my house, Joao, and I'll be happy to offer you beer too.
Just let me know what you drink

Maybe it sounds more complicated than it really is -- it took about an
hour to build one side with some 2x6 and 2x3 lumber. I'll post some
pictures so you get an idea.

I was really more worried about where to support the body from when it
is off. Using the current idea, it is supported by basically the
corners, just within in the wheelwell area.

Remco