Hi, Thanks, excellent sites. Weavermill didn't mess around cutting corners.
In a sudden passion for the hobby I may take the plunge, but I am probably
too cheap and lazy right now. I will wait and see if something breaks and
forces my hand, otherwise, color me yellow thx
"waynec" > wrote in message
news:RjjEe.334$eg4.226@trndny01...
> 700R4:
> http://www.bowtieoverdrives.com/index.shtml
>
> Richmond 5-speed:
> http://www.weavermill.com/trans/richmond.htm
> http://www.corvettefaq.com/c3/Richmond_install.pdf
>
> Tremec:
> http://temp.corvetteforum.net/c3/gwhite75/
>
> Elwood wrote:
> > Hi, am wondering about the feasibility of swapping the Muncie out for
one of
> > the side loaders from an early eighties Chevy truck. I think GM calls it
the
> > NP260 (MY6) which I guess is like the old New Process A833, which is
really
> > a 3 speed with Overdrive. The ratios are :3.090 1.670 1.000 0.730 It's
> > basically a stock engine, so with 180 HP am not too concerned about
tearing
> > it up. The looks and runs great, but the truth be told, my wife and
daughter
> > are the only ones that drive it. If it got better mileage and it was an
> > easy swap, I might go visit the wrecker. So if you can clue me in on
> > splines, yolks, tail shafts and shifter placement,ect, I'd be much
obliged,
> > thx
> >
> >
>