The Pinion Angle and the Tcase Output shaft should be parallel, not on a
straight line to each other.
"Nathan Otis" > wrote in message
...
>I thought I had my pinion angle adjusted pretty well Sunday when I attached
>the driveshaft, but I have a vibration that starts at about 40mph, dies off
>at around 50 and picks up again at about 60.
>
> My helper and I held a carpenters square (the big L shaped one) on the
> diff and lined it up that way, pointing directly at the output of the
> transfercase... Can anyone give tips that will get me dead on?
> n.
>
|