I do have the CV.
n.
> wrote in message
...
> bad!
> the output shaft of the transfer case and the output from the rear
> differential should be parallel within 5 degrees or you will get a
> vibration.
> this is not true if you have a double u joint(cv joint)
> then what you have done applies.
> old john
>
>
> "Nathan Otis" > wrote in message
> ...
>> I thought I had my pinion angle adjusted pretty well Sunday when I
> attached
>> the driveshaft, but I have a vibration that starts at about 40mph, dies
> off
>> at around 50 and picks up again at about 60.
>>
>> My helper and I held a carpenters square (the big L shaped one) on the
> diff
>> and lined it up that way, pointing directly at the output of the
>> transfercase... Can anyone give tips that will get me dead on?
>> n.
>>
>>
>
>
|