All BMW wiring connectors have some sort of locking provision built into
them. It's been a long time since I replaced my wiper linkage but I think
the connector used the wire spring lock which is just like the one on the
air flow meter. You need a very small screwdriver or hook to pull the wire
lock out of its groove before attempting to remove the connector. Practice
on the air flow meter where you can see what you're doing.


> wrote in message
oups.com...
> Hi,
>
> I'm trying to remove the wiper motor to clean the grease off the
> contacts as its growling and the arms are refusing to return to the
> park position.
>
> I'm attempting to get it out through the small vent hole on the
> passenger side but at the moment I can't seem to disconnect the
> electrical plug / connector. Whats the trick with this connector?
> Please reply before I loose patience and cut the wires, thinking that
> it might be OK to splice them back in later.
>
> Thanks in advance,
>
> Al.
>
> Also if it turns out that I need a new/second hand wiper motor any
> suggestions of where to get one appreciated!
>