The wire isn't being upgraded due to a bigger gauge, I just thought it
would be better to run new wire since in the Caravan, the dash
speakers are running in parallel with the door speakers. The new
components would definitely not support this type of wiring, not to
mention they need to be directly wired to the crossover.

I do have an after market deck in - the pci bus you mention, would I
only need to worry about that with a factory deck? I'm not sure what
it is.

Michael


On Sun, 09 Jul 2006 18:09:54 -0400, philthy <"noway "@ seeya.net>
wrote:

>are you running bigger gauge wire for the components? due to a amp upgard then
>
>u will need to piggybac wires the best you can in the boot to the bbot are
>remove the factory wires and replace with your new ones, if not then use the
>factory wires on both side of the door and jamb like were it goes thru th ekick
>panel t the door jamb boots and hook up your crossover there but the factory
>only tells you which one is positive in th e factory manual so you will need to
>get tahat figured out or you will be wasting your time i hope you got a new
>head unit>
>you do have to be careful since the pci bus does interface with the factory
>radio...it's a little white connector on the bac of the radio that only has two
>wires in it and one may be missing hope this helps you in some way