Thread: Locker abuse
View Single Post
  #2  
Old June 1st 05, 11:10 PM
Mike Romain
external usenet poster
 
Posts: n/a
Default

Naw, your stuff is better Jeff....
;-)

"One thing that has me
worried is the metal "ring" at the outer end of the axle tube."

LOL!

Mike


Jeff Strickland wrote:
>
> The Original Poster asked,
> "... I'm looking for advice on the replacement job. This is for an '85 CJ-7
> Dana 30 - passenger's side. Are there any gotcha's out there? Does ..."
>
> I don't know what you are smoking, but I could use some.
>
> "L.W. (ßill) Hughes III" > wrote in message
> ...
> > Jeff?????????
> > The Original Poster was worried about a loose deflector shield
> > that's ordinarily pressed on to the axle shaft, or just plastic on later
> > model Dana 30s:
> >

> http://web.archive.org/web/200407240...s_DSCF0013.JPG
> > And you think his talking about the wheel bearing seal??????????
> > God Bless America, ßill O|||||||O
> > http://www.billhughes.com/
> >
> > Jeff Strickland wrote:
> > >
> > > Thank you Captain BesideThePoint. The OP was asking specifically about

> an 85
> > > CJ, there is an outer seal on the hub, where the hub and spindle meet.
> > >
> > > "L.W. (ßill) Hughes III" > wrote in message
> > > ...
> > > > Hi Jeff,
> > > > There is one outer seal on the YJ axle disconnect side only. All
> > > > the rest of the Dana 30s just use the one per side at the housing:
> > > > http://www.billhughes.com/dana30seals.jpg
> > > > God Bless America, ßill O|||||||O
> > > >
> > > >
> > > > Jeff Strickland wrote:
> > > > >
> > > > > There are outer seals too, Mike. I think I was referring to these

> outer
> > > > > seals when I wrote that procedure.

Ads