View Single Post
  #1  
Old September 22nd 04, 10:54 PM
Oppie
external usenet poster
 
Posts: n/a
Default Update on SES light lw300

After getting a P0495 code again (evap canister large leak) I changed the
canister vent solenoid. Evidently cleaning out the old valve was not
effective. New valve was about $20 from Saturn parts (not available on
aftermarket). Took about an hour to install including getting the rear end
up on jack stands.

It's been a week and the SES lamp is still off. Either this is the fix of
the controller is not meeting conditions for the test. The code was set in
hot weather and it has been fairly temperate in NYC this week. Time will
tell.

While at Saturn, asked about a locking gas cap. was out of stock but
available at $26, about the cost of a siphoned tank of gas and far less than
the cost of a cup of sugar in the tank : (


Ads