After you get your pan in and your pedal cluster mounted, figure out
where the brake pedal stop needs to go. The drill a hole in the middle
of the slot and weld a nut on the bottom of the pan. You can then bolt
the pedal stop from the top.

MK wrote:
> I'm about to remove the drivers side front floor pan section, and noticed
> that the new pan section doesn't come with a mount for the brake stop plate.
> Due to the amount of previous repair/patches on my existing floor, I can't
> tell how the plate mounts. It's just screwed into a mound of
> rust/paint/fiberglass. Does anyone have pictures of what this should look
> like on a new pan? Would I need to weld a reinforcing plate above, or below
> the new pan (crappy brazilian metal, I'd never go that route again)
>
> Thanks in advance,
> Mike Kayer
>
>
>