"Mark N" > wrote in message >...
> Just as the subject line says...
>
> I would like to install a oil pressure gauge, alongside a oil temperature
> gauge (i like gauges) but am not sure how to do this. I did this on a VW i
> had a few years ago and it was just a cast of removing a bolt from the
> engine block and screwing the pressure transducer into it. but that engine
> was FAR simpler than this thing...
>
> Any suggestions.
There are people who did this on the italian 147 forum
(
www.147virtualclub.it). If you don't read italian (that can be
understood, in certain cases...) you can roam around the forums and
ask in english, they're usually very helpful).
Good luck.