Water isn't good for axles. If the fluid is milky, change it. Ditto for
the transmission. The seals used are designed to keep oil in, not water
out.

Earle

> wrote in message
oups.com...
> OUCH. Took the Jeep through a tiny puddle this past week. Almost made
> it through, but the engine stalled. Found out it was the deepest water
> hole there. Water poured in from the front of the passenger side, but
> not the driver side.
>
> Got pulled out and took out the soaked Air Filter. After sitting for a
> few minutes, we jump started it and it ran fine. Engine light was on
> for the next day or so, then went out. Stuck a fan in and dried out
> the floor.
>
> Anything else I should be concerned about? (and quit you laughing!!)
>