That'll work.
Another, quicker option is to put a VERY short tack weld on the offending
part.
Don't whale on it with the heat gun-- you'll change the temper of the spring
and be up the creek.
"Roger Brown" > wrote in message
...
> dcbryan wrote:
> >
> > After looking at AutoZone.com I have determined that the proper name for
the
> > item I am talking about may be called the spring clip.
>
> Spring clips are typically riveted in place, so one option is to tighten
> up the rivet, usually invovles removing and dis-assembling the spring
> pack. Other option is to run a bead of silicone sealer along the clamp,
> where it attached to the lower leaf. This should hold it in place to
> keep from rattling, yet allow the upper leaves to slide back and forth
> through it.
>
> --
> Roger
|