Forum: Corvette
November 15th 08, 12:31 PM Posted to alt.autos.corvette
|
Replies: 5
Views: 591
|
Forum: Corvette
November 7th 07, 01:54 PM Posted to alt.autos.corvette
|
Replies: 26
Views: 1,034
Help justifying a vette
its a toy..
u dont have to justify toys
http://community.webtv.net/jcorvette/MYMOSAICS
http://community.webtv.net/jcorvette/JEROMESMOSAICS
|
Forum: Corvette
July 28th 07, 02:45 PM Posted to alt.autos.corvette
|
Replies: 1
Views: 603
Rag joint on a '76 shark question
that does seem strange..
when u buy the new rag joint inspect it first it may reveal your answer
i repleced the rag joint on my 72
i was one notch off and it made the steering wheel off center..i...
|
Forum: Corvette
June 26th 07, 12:55 PM Posted to alt.autos.corvette
|
Replies: 3
Views: 655
|
Forum: Corvette
June 14th 07, 01:48 PM Posted to alt.autos.corvette
|
Replies: 9
Views: 564
brakes on the 72 Update
i started on frt wheels of course...right rotor was warped. when i
pulled off the right tire the back
of tire and wheel were wet from silicone brake fluid
i pulled the caliper off and seen where i...
|
Forum: Corvette
June 8th 07, 02:42 PM Posted to alt.autos.corvette
|
Replies: 9
Views: 564
brakes on the 72
thx guys .i will work on bleeding and checking runout.
the MC seems to be fine. we did bench bleed it
thx again
http://community.webtv.net/jcorvette/MYMOSAICS
|
Forum: Corvette
June 7th 07, 12:56 PM Posted to alt.autos.corvette
|
Replies: 9
Views: 564
brakes on the 72
after i rebuilt all the calipers anf bled the system twice the brakes
seemsd to work fine then gradually the brake pedal got softer and
softer. the pedal going almost to the floor. the car stops fine...
|
Forum: Corvette
May 28th 07, 01:47 PM Posted to alt.autos.corvette
|
Replies: 15
Views: 1,235
|
Forum: Corvette
March 16th 07, 01:00 PM Posted to alt.autos.corvette
|
Replies: 4
Views: 408
Header Coating : Go with Jet Hot ???
ive had jet-hot on my headers for several years..stil look great.even
got 20 dollars off shipping
that was then tho
http://community.webtv.net/jcorvette/MYMOSAICS
|
Forum: Corvette
March 4th 07, 01:59 PM Posted to alt.autos.corvette
|
Replies: 7
Views: 881
Brake line replacement on 63 early question
i did all the brake lines on my 72, its not all that difficult .it takes
time but ive done more difficult jobs. its worth the sweat and busted
knuckes// get some rust spray and tubing...
|
Forum: Corvette
January 8th 07, 01:02 PM Posted to alt.autos.corvette
|
Replies: 2
Views: 405
tilt column question
my wifes cousin has a chevy van that was stolen and recovered..they
busted the hell out of the cloumn on the left side so they could get to
the slide mechanism which has the rod down to the wiring...
|
Forum: Corvette
December 11th 06, 01:15 PM Posted to alt.autos.corvette
|
Replies: 4
Views: 209
|
Forum: Corvette
November 26th 06, 03:11 PM Posted to alt.autos.corvette
|
Replies: 1
Views: 177
Grease recommend whl. bearings+ ujoints 1963?
i typically use wheel bearing grease/
it says it on the package usually.
nothing more than high temp grease
for u-joints use a the same grease u use for ball joints and steering
joints
|
Forum: Corvette
November 8th 06, 12:32 PM Posted to alt.autos.corvette
|
Replies: 3
Views: 223
|
Forum: Corvette
November 7th 06, 03:48 PM Posted to alt.autos.corvette
|
Replies: 3
Views: 223
heater electrical problems
the fan switch on my 72 only runs on one speed. is this a switch problem
or a relay problem or both
another question. what does the resistor do and could it cause a
problem.
thx in avance
jeorme
|
Forum: Corvette
July 31st 06, 11:51 AM Posted to alt.autos.corvette
|
Replies: 10
Views: 799
Bad Harmonic Balancer
im sure u need a new balancer. the rubber cant be replaced as its a
factory assembly.
u will need a balancer remover and a balancer installer. im not sure of
your situation on a 98 but you should be...
|
Forum: Corvette
July 11th 06, 02:39 PM Posted to alt.autos.corvette
|
Replies: 6
Views: 793
|
Forum: Corvette
July 9th 06, 02:17 PM Posted to alt.autos.corvette
|
Replies: 6
Views: 793
need advise on c3 radiator
there is a radiator rebuild place in nashvill tn.
good prices and fast shipping
good luck
Im sorry if you dont like my attitude but its the only one i have
|