AutoBanter

AutoBanter (http://www.autobanter.com/index.php)
-   Chrysler (http://www.autobanter.com/forumdisplay.php?f=10)
-   -   Anti-Theft Alarm Problem 99 Intrepid (http://www.autobanter.com/showthread.php?t=8729)

Arthur November 5th 04 08:15 PM

Anti-Theft Alarm Problem 99 Intrepid
 
I have a factory-installed anti-theft alarm built into my 99 Intrepid.
Lately, after arming the alarm with my key fob, the red light on top of the
dashboard remains on solidly for a period of time, and then begins to flash.
Normally, the red light flashes rapidly and then flashes more slowly. I
checked the manual and it says if the light on the dash illuminates solidly
when the alarm is activated, there is trouble with the trunk. A couple of
times, the alarm went off (lights and horn) when I closed the trunk lid
even though I disabled the alarm first. Does anyone here know a simple fix
for this problem or is a trip to the dealer on my 'things to do' list once
again?

Thanks in Advance,
Arthur



maxpower November 5th 04 09:35 PM

If the alarm was set you can still open the trunk, it isnt a switch that
opens and closes to activate it, You have to physically punch out the trunk
lock cylinder to set it off Vehicle Theft Security System
This passive system is designed to protect against vehicle theft. The
vehicle theft security system

(VTSS) is part of the body control module, which monitors vehicle doors and
the ignition for

unauthorized operation. The alarm activates by sounding the horn, flashing
the headlamps, park

and tail lamps, and the VTSS indicator lamp, and providing an engine 9no
run9 feature. Passive

arming occurs upon normal vehicle exit by turning the ignition off, opening
the driver's door,

locking the doors with the power lock, and closing the driver's door or
locking the doors with RKE.

Manual arming occurs by using the key to lock the doors after closing them.
The indicator lamp

on the dash will flash for 15 seconds, showing that arming is in progress.
If no monitored systems

are activated during this period, the system will arm and the indicator will
flash at a slow rate. If

the indicator lamp remains steadily lit during the arming process, this can
indicate a possible loss

of communication with the PCM or loss of trunk knock out switch. When
something triggers the

alarm, the system will signal the headlamps, park lamps, and horn for about
3 minutes.

For complaints about the Theft Alarm going off on it's own use the DRB and
select 9Theft Alarm9

then 9Monitor Display9 and read the 9Alarm Tripped By9 status.

Tamper Alert - The VTSS indicator lamp will flash twice quickly to indicate
a tamper condition has

occurred.

Manual Override - The system will not arm if the doors are locked using the
manual lock control

(by hand) or if the locks are actuated by an inside occupant after the door
is closed. When an

unauthorized entry into the vehicle occurs, the VTSS sends a message via the
PCI bus to the

powertrain control module that it is NOT OK to start the engine. The
powertrain control module

GENERAL

INFORMATION

15

om> wrote in message ...
> I have a factory-installed anti-theft alarm built into my 99 Intrepid.
> Lately, after arming the alarm with my key fob, the red light on top of

the
> dashboard remains on solidly for a period of time, and then begins to

flash.
> Normally, the red light flashes rapidly and then flashes more slowly. I
> checked the manual and it says if the light on the dash illuminates

solidly
> when the alarm is activated, there is trouble with the trunk. A couple of
> times, the alarm went off (lights and horn) when I closed the trunk lid
> even though I disabled the alarm first. Does anyone here know a simple

fix
> for this problem or is a trip to the dealer on my 'things to do' list once
> again?
>
> Thanks in Advance,
> Arthur
>
>




maxpower November 5th 04 09:35 PM

If the alarm was set you can still open the trunk, it isnt a switch that
opens and closes to activate it, You have to physically punch out the trunk
lock cylinder to set it off Vehicle Theft Security System
This passive system is designed to protect against vehicle theft. The
vehicle theft security system

(VTSS) is part of the body control module, which monitors vehicle doors and
the ignition for

unauthorized operation. The alarm activates by sounding the horn, flashing
the headlamps, park

and tail lamps, and the VTSS indicator lamp, and providing an engine 9no
run9 feature. Passive

arming occurs upon normal vehicle exit by turning the ignition off, opening
the driver's door,

locking the doors with the power lock, and closing the driver's door or
locking the doors with RKE.

Manual arming occurs by using the key to lock the doors after closing them.
The indicator lamp

on the dash will flash for 15 seconds, showing that arming is in progress.
If no monitored systems

are activated during this period, the system will arm and the indicator will
flash at a slow rate. If

the indicator lamp remains steadily lit during the arming process, this can
indicate a possible loss

of communication with the PCM or loss of trunk knock out switch. When
something triggers the

alarm, the system will signal the headlamps, park lamps, and horn for about
3 minutes.

For complaints about the Theft Alarm going off on it's own use the DRB and
select 9Theft Alarm9

then 9Monitor Display9 and read the 9Alarm Tripped By9 status.

Tamper Alert - The VTSS indicator lamp will flash twice quickly to indicate
a tamper condition has

occurred.

Manual Override - The system will not arm if the doors are locked using the
manual lock control

(by hand) or if the locks are actuated by an inside occupant after the door
is closed. When an

unauthorized entry into the vehicle occurs, the VTSS sends a message via the
PCI bus to the

powertrain control module that it is NOT OK to start the engine. The
powertrain control module

GENERAL

INFORMATION

15

om> wrote in message ...
> I have a factory-installed anti-theft alarm built into my 99 Intrepid.
> Lately, after arming the alarm with my key fob, the red light on top of

the
> dashboard remains on solidly for a period of time, and then begins to

flash.
> Normally, the red light flashes rapidly and then flashes more slowly. I
> checked the manual and it says if the light on the dash illuminates

solidly
> when the alarm is activated, there is trouble with the trunk. A couple of
> times, the alarm went off (lights and horn) when I closed the trunk lid
> even though I disabled the alarm first. Does anyone here know a simple

fix
> for this problem or is a trip to the dealer on my 'things to do' list once
> again?
>
> Thanks in Advance,
> Arthur
>
>





All times are GMT +1. The time now is 12:59 AM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
AutoBanter.com