How do I increase the water temp for winter
Hello,
I use to just replace the thermostat in my older GM cars for a 190 degree but not sure how to increase the temp in my 96 Voyager 3.3L Can it be done because it seems when the temp needle is in the middle after warm up period its not all that hot. I don't have the rear AC or heat. Any suggestions would be appreciated. Thanks, Greg |
"Hola" > writes:
> > I use to just replace the thermostat in my older GM cars for a 190 degree > but not sure how to increase the temp in my 96 Voyager 3.3L > Can it be done because it seems when the temp needle is in the middle after > warm up period its not all that hot. > I don't have the rear AC or heat. I would expect that vehicle to already have a 195 degree thermostat. Why do you feel that it's "not all that hot?" Are you talking about the engine temp (as implied by the remark about the temp gauge) or the heater? -- Joseph J. Pfeiffer, Jr., Ph.D. Phone -- (505) 646-1605 Department of Computer Science FAX -- (505) 646-1002 New Mexico State University http://www.cs.nmsu.edu/~pfeiffer |
"Hola" > writes:
> > I use to just replace the thermostat in my older GM cars for a 190 degree > but not sure how to increase the temp in my 96 Voyager 3.3L > Can it be done because it seems when the temp needle is in the middle after > warm up period its not all that hot. > I don't have the rear AC or heat. I would expect that vehicle to already have a 195 degree thermostat. Why do you feel that it's "not all that hot?" Are you talking about the engine temp (as implied by the remark about the temp gauge) or the heater? -- Joseph J. Pfeiffer, Jr., Ph.D. Phone -- (505) 646-1605 Department of Computer Science FAX -- (505) 646-1002 New Mexico State University http://www.cs.nmsu.edu/~pfeiffer |
Sounds like something else going on. My 96 caravan 3.3 engine temp gauge
also sits right smack in the middle, using the original OEM thermostat, and it pumps out lots of nice hot heat from the heater. Maybe the heater core is partially blocked. I would also run the HVAC calibration test - maybe the heat is not actually going to full hot when you move the slider all the way to the right. You might also find a fault with the heat control motor. "Hola" > wrote in message . .. > Hello, > > I use to just replace the thermostat in my older GM cars for a 190 degree > but not sure how to increase the temp in my 96 Voyager 3.3L > Can it be done because it seems when the temp needle is in the middle > after warm up period its not all that hot. > I don't have the rear AC or heat. > > Any suggestions would be appreciated. > > Thanks, > > > Greg > |
Sounds like something else going on. My 96 caravan 3.3 engine temp gauge
also sits right smack in the middle, using the original OEM thermostat, and it pumps out lots of nice hot heat from the heater. Maybe the heater core is partially blocked. I would also run the HVAC calibration test - maybe the heat is not actually going to full hot when you move the slider all the way to the right. You might also find a fault with the heat control motor. "Hola" > wrote in message . .. > Hello, > > I use to just replace the thermostat in my older GM cars for a 190 degree > but not sure how to increase the temp in my 96 Voyager 3.3L > Can it be done because it seems when the temp needle is in the middle > after warm up period its not all that hot. > I don't have the rear AC or heat. > > Any suggestions would be appreciated. > > Thanks, > > > Greg > |
|
|
Its the heat is insufficient, as like what happened today, we had freezing
rain and I had it on defrost middle blower speed, temp gauge needle in middle. It was ok at a stop light which would melt the freezing rain but as soon as I start driving the freezing rain starts clogging on the windshield. I would think the heat should be strong enough to keep the freezing rain from freezing while driving. I bought the 96 Voyager used from a dealer, and by the maintenance records it looks well taken care of by a dealer etc... I have not check to see what temp thermostat is there. How about the electric cooling fans, at what engine temp do they turn on? Thanks, Greg "Joe Pfeiffer" > wrote in message ... > "Hola" > writes: >> >> I use to just replace the thermostat in my older GM cars for a 190 degree >> but not sure how to increase the temp in my 96 Voyager 3.3L >> Can it be done because it seems when the temp needle is in the middle >> after >> warm up period its not all that hot. >> I don't have the rear AC or heat. > > I would expect that vehicle to already have a 195 degree thermostat. > Why do you feel that it's "not all that hot?" Are you talking about > the engine temp (as implied by the remark about the temp gauge) or the > heater? > -- > Joseph J. Pfeiffer, Jr., Ph.D. Phone -- (505) 646-1605 > Department of Computer Science FAX -- (505) 646-1002 > New Mexico State University http://www.cs.nmsu.edu/~pfeiffer |
Its the heat is insufficient, as like what happened today, we had freezing
rain and I had it on defrost middle blower speed, temp gauge needle in middle. It was ok at a stop light which would melt the freezing rain but as soon as I start driving the freezing rain starts clogging on the windshield. I would think the heat should be strong enough to keep the freezing rain from freezing while driving. I bought the 96 Voyager used from a dealer, and by the maintenance records it looks well taken care of by a dealer etc... I have not check to see what temp thermostat is there. How about the electric cooling fans, at what engine temp do they turn on? Thanks, Greg "Joe Pfeiffer" > wrote in message ... > "Hola" > writes: >> >> I use to just replace the thermostat in my older GM cars for a 190 degree >> but not sure how to increase the temp in my 96 Voyager 3.3L >> Can it be done because it seems when the temp needle is in the middle >> after >> warm up period its not all that hot. >> I don't have the rear AC or heat. > > I would expect that vehicle to already have a 195 degree thermostat. > Why do you feel that it's "not all that hot?" Are you talking about > the engine temp (as implied by the remark about the temp gauge) or the > heater? > -- > Joseph J. Pfeiffer, Jr., Ph.D. Phone -- (505) 646-1605 > Department of Computer Science FAX -- (505) 646-1002 > New Mexico State University http://www.cs.nmsu.edu/~pfeiffer |
On Tue, 7 Dec 2004 17:52:16 -0500, "Hola" >
wrote: >Its the heat is insufficient, put a piece of cardboard in front of the rad. ....thehick |
All times are GMT +1. The time now is 04:15 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
AutoBanter.com