gas gauge 12 volt conversion question
Braukuche wrote:
> My Bus has been converted to 12 volt by the PO and the gas gauge doesn't work. > There is no votlage reducer on it and I doubt they installed a 12 volt gauge, > so my question is does a six volt gauge need a voltage reducer? OF course it > has a 12 volt bulb in it. > Thanks, > --Dan E Yeah, it should have a reducer. You'd need a solid-state voltage regulator type, not a resistor. That's an old Bus? See my web site for the type gauge- yours should be voltmeter-type rather than newer thermal. Test by grounding the wire to the sender. Also check that there actually is voltage going *to* the gauge. You can also measure resistance of the sender to ground to see if it is good. Speedy Jim http://www.nls.net/mp/volks/ |
All times are GMT +1. The time now is 11:43 PM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
AutoBanter.com