A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Chrysler Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
GM Using The Mercedes Playbook by who
In article >, " > wrote: > If Gentz is right, if the Germans were overly concerned with being > seen as ''invaders,'' then this culturally motivated hesitation cost > the...
August 8th 10 09:01 PM
by who Go to last post
2 399
Temperature readout frozen by Ashton Crusher[_2_]
The dash display of outside temp on my 09 PT was frozen at 83 degrees no matter what the outside temp was. Gas mileage seemed to have dropped a lot too. So I disconnected the battery for half an hour. Reconnected it and the temp display was working correctly again. After putting a few miles on it...
August 8th 10 05:28 AM
by Ashton Crusher[_2_] Go to last post
0 383
Low Oil Pressure Reading/1991 New Yorker by sctvguy1[_2_]
I have the 3.8 engine, 78k original miles. The oil was changed last month, but the needle gauge reads at the low end of H-L scale. Sometimes it drops, then other times it rises a bit. Is this an indication of needing a new oil pressure sensor? The engine is smooth, no noises, the oil level...
August 1st 10 11:50 PM
by Daniel who wants to know Go to last post
1 322
I got the Tranny Fluid in the PT changed by Pete E. Kruzer[_2_]
I specified to ONLY USE the Chrysler fluid for these transmissions. The bill reads: Tranny R/R Tranny Pan, Change Fluid and and filter kit. Tranny Filter Transmission Filter Kit. 5 quarts Transmission Oil @ $3 each. SB101 Chrysler Trans Fluid Additive. What is this additive? Should I assume that...
(Multi-page thread 1 2)
July 31st 10 04:33 AM
by Ashton Crusher[_2_] Go to last post
10 787
2002 GC Headlight Problem... by Newman
Here's a weird one... Most of the time, but not *all* the time, I only have one headlight! This all started a few weeeks ago. I thought I had a burnt out bulb on the driver's side. So when I was at one of those oil change places I asked them to replace it. When he did (twice) it still did not...
July 28th 10 05:32 PM
by Daniel who wants to know Go to last post
5 642
Is RAM no longer a Dodge brand? by MoPar Man
I got an unsolicited multi-page Ram truck brochure in the mail. The word "Dodge" does not appear anywhere. Have those god-damn italian *******s at Fiat de-branded Ram and taken it away from Dodge?
July 27th 10 03:04 PM
by sctvguy1[_2_] Go to last post
7 584
GOODBYE to the PT Cruiser by JLA
From AB *** Chrysler's long-lived PT Cruiser will finally roll off into the sunset next month after a decade in production. According to the Detroit Free Press, when the 2010 model year winds down at Chrysler's Toluca, Mexico plant on July 9, the final Cruisers will be produced. The retro-styled...
(Multi-page thread 1 2)
July 21st 10 06:30 PM
by sctvguy1[_2_] Go to last post
17 883
1949 Chrysler Royal by Nza
Howdy everyone, don't know if any of you will remember the thread I started (and got plenty of great information) about three years ago (i guess).. I have a 1949 Chrysler... thought it was going to be a piece of cake to get it running again... after cranking a billion times, i pulled the cylinder...
July 21st 10 03:47 PM
by Nza Go to last post
7 475
2000 Concorde LXi (1) Exhaust Leak (2) Door Actuator by jaygreg
I’ve got a leak on the drivers side of the engine at the “band clamp” (pg 11-7 Fig.7 of the orange 2000 Service Manual). I’m having a radiator fan replaced Thursday for the second time in a year (passenger’s side failed twice) and since the car can be hoisted while there, I’m wondering if there’s...
July 20th 10 07:59 PM
by jaygreg Go to last post
0 337
Toledo plant expansion has been DELAYED by Chrysler by JLA
From AB It's no secret that Chrysler's future plans are in a constant state of flux right now. After all, the automaker just went through a ridiculously fast bankruptcy where bits and pieces were shed before stewardship was handed over to Italy's Fiat. It's only natural that Chrysler's new...
July 19th 10 11:17 PM
by JLA Go to last post
0 368
Can Chrysler Towne & Country anti theft be reset by owner? by Pete E. Kruzer[_2_]
When we were getting ready to leave VA Beach, the couple/child from WV were having car trouble. The Towne and Country would start, run for a couple of seconds, and quit. Sounded to me like the anti theft software kicked in. The car will start, and then shut the current off to the fuel injectors....
July 18th 10 05:13 PM
by Pete E. Kruzer[_2_] Go to last post
0 649
2000 T&C Van / How to remove front cup holder assembly by SID
Hi; I need to remove the front cup holder assembly from the van. It's the one in the center console just below the heat/ac control panel. The power outlet (cigar lighter) broke and most of the parts fell in behind the face. Now to replace the lighter I need access to the back and the best way seems...
July 17th 10 05:30 PM
by SID Go to last post
0 302
300M timing belt: it's time -- but where? by Percival P. Cassidy
Our 300M's timing belt is now due for replacement, but I am wondering how much difference it makes where I have the job done. I am planning to have the water pump, tensioner and pulley replaced all at the same time. The single-location Chrysler dealership where we had all our service done...
July 9th 10 08:10 PM
by rob Go to last post
1 530
Steering wheel play in Stratus by LarryK
I've noticed recently about an inch or so of play in the steering wheel of my '02 Stratus, with 133K on the clock. Hopefully I will be getting it in the shop soon to be checked out, but is this always a sign that the rack is going, or could it be something less extensive (and expensive), such...
July 9th 10 12:12 AM
by LarryK Go to last post
2 654
Another 2001 PT bumper facia question (white marks) by Pete E. Kruzer[_2_]
I was reading an article on the reason for the white marks on 01 - 03 Cruiser white marks. It said that it was caused by masking the bumpers before the car went through the paint booth. The heat pulled the resin from the tape causing the white marks to show up later. If this is the reason, then why...
July 7th 10 02:42 PM
by Pete E. Kruzer[_2_] Go to last post
0 340
1992 Dodge Grand Caravan Alternator removal by Hachiroku $B%O%A%m%/(B[_2_]
Anybody lend a hand? This is a '92 Grand Caravan with a 3.3L engine. What's the easiest way to remove the alternator from this thing?
(Multi-page thread 1 2)
July 7th 10 04:09 AM
by Hachiroku $B%O%A%m%/(B[_2_] Go to last post
12 966
1997 LHS spark plug wire replacement by katherat
I understand that my LHS has Coil-on-plug ignition. Apparently that is why the replacement splark plug wire set that I just ordered has those long plastic tubes? How do I remove the existing wires? When I pull up on the forward-most spark plug wire on the passenger side (which seems to be the most...
(Multi-page thread 1 2)
July 5th 10 02:58 AM
by Joe Pfeiffer Go to last post
14 874
1998 Plymouth Voyager "Service Engine Soon" light by Kit[_2_]
1998 Plymouth Voyager “Service Engine Soon” light came on… Using the “On-off-on-off-on” ignition key trick yielded codes #35 and #42. Code 35 Radiator Fan Relay I had the Radiator Fan Relay replaced last year, on the basis of a diagnosis (by a dealer) that the "service engine soon" code ...
July 2nd 10 06:53 PM
by Kit[_2_] Go to last post
0 1,537
1999 RAM VAN Seats by DJ[_6_]
(Sorry if you read this already -- Reposted from alt.autos.dodge) Hi all, I need to replace the power seat track in my 99 RAM VAN. My wife either raised or lowered it with an aluminum bat wedged under there and snapped the shaft that runs all the way across the front. Does anyone know which...
June 21st 10 03:27 PM
by DJ[_6_] Go to last post
0 330
1997 Dodge by Gary[_12_]
We are driving a 97 Dodge 6cyl Caravan with 160,000 mileson it.It still runs strong but we are thinking of getting a brand new vehicle within the next year.I see a lot of 4 cylinders in the paper.To put it bluntly."Are they any good"? Do they burn out ear;ier than 6s? Whats a good company? Are...
June 13th 10 04:58 AM
by Gary[_12_] Go to last post
3 416
Post New Thread


Display Options
Showing threads 361 to 380 of 6940
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 07:14 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.