It's time to replace at least one of the front wheel bearings on my '90 Plymouth Grand Voyager. The parts distributors generally seem to not stock the bearings themself but rather they stock a complete front wheel hub. Is there a reason why just the bearings can't be replaced? John...

How do pull the assembly to replace it I have found the two obvious points on the front but there seems to be a third I can't find.

My parents own a 1991 Plymouth Grand Voyager SE with a 3.3 V6 engine and a 4-speed automatic transmission. When they were taking some big stuff over to a store for refunds, they ran into a couple of problems with the van. 1st: During the day, the van was running fine at first. But when my...

Hello, I have a '92 Dodge Dynasy with 190,000 miles on it. As I was driving home from work, the car shifted suddenly into 2nd gear (limp mode?) and now will not shift into a higher gear. It was a very sudden change at about 45 MPH. Using the ON-OFF-ON-OFF-ON-OFF method, there are no codes...

There is something very wrong with the electrical. The tack needle sits at 6000rpm and does not move. When it's in that position, the radio, and interior light do not work. At other times the tack gets burried at 7000+, when it is in that position everything works fine. Then sometimes magically it...

Hello everyone. My '92 Plymouth Sundance 2.5L engine have been consuming too much oil. From full to empty on the dipstick takes only over a week. Months ago, I changed the valve cover gasket and a hose from the valve cover to the air cleaner, properly clipped. Yesterday, I found that another...

I recently completed an engine rebuild on a 2.5 4cylinder engine in the above vehicle. I did the rebuild because the engine was burning about a quart every 40 miles and had no oil pressure. Also, it had a lot of what sounded like lifter noise.. a real racket, it drowned out the radio at highway...

Hi again. I also have a 1992 dodge spirit that runs great when warmed up, and starts fine when it is warm outside, but when it is cold, it keeps stalling when started. you have to baby it for the first 5 minutes to keep it running, then it is fine. I have a remote starter on it, but what is the use...

Reposted from al.dodge... Another engineer I'd like to punch in the nose, but that's for another thread: 1992 Plym Grand Voyager: this morning in a raging snowstorm the pass side windshied wiper stopped working. It appeared as though (from the sound) the linkage came undone. I removed the...

Hello, I have a 1993 Plymouth Acclaim 3.0L V6 w/ Automatic transmission. This evening the check engine light came on. I obtained the error code by doing the self diagnosis where you rev the engine up, turn the ac on/off, Shift thru all the gears and then turn the Ingition key ON, OFF, ON, OFF and...

'93 Grand Cherokee Limited 5.2L. This little pin mysteriously appeared beneath my driveshaft while pulling my right rear wheel bearing. It had a light coating of oil over it which kinda smells like gear oil. Any idea where it came from? I've been told that it looks like a shaft lock pin for...

Simple question, are there any? I went to drain the coolant on my 3.0L the other day and I'll be damned if I could spot any drain plugs on the block. Maybe I was looking in the wrong place. *shrug* -- Posted via a free Usenet account from http://www.teranews.com

The easy part. Should I fill my tranny with ATF+4 or search for +3? It seems most of the local places only have +4 now. It's a '93 Grand Voyager 3.0L, 3 speed auto (A670 I would imagine), 203k kms. The harder part. This tranny has always had hard upshifts, especially when cold. By hard I mean it...

My father's '93 Grand Voyager (3.0L, auto, 178k kms) decided not to start today when he really needs it (it has been converted to a wheelchair van for my brother long ago, a real lifesaver to say the least). She'll crank over all day but won't catch. I do hear the fuel pump running for a few...

I have a '93 Grand Voyager with about 146k miles on it. It's developed a terrible loud engine knock that is progressing. When it started months ago, it was only when the engine got to normal temp but now it's from the time you start it up and getting louder all the time. It sounds like a diesel...

On a 1993 Intrepid, are the bolts that connect the trailing arms to the rear spindle dealer only items? Or are they standard bolts? Thanks, kurt

I can't get a hard petal while my car is running. We have replaced the master cylider 4 times, can find no leaks, blead the breaks dry, changed any questionable break lines. The stroke is fine, the regulator valve is fine. We tried everything we could think of. Anyone ever heard of a similar...

I have a '93 Grand Voyager with about 146k miles on it. It's developed a terrible loud engine knock that is progressing. When it started months ago, it was only when the engine got to normal temp but now it's from the time you start it up and getting louder all the time. It sounds like a diesel...

Hopefully, it's a simple question My husband was given this vehicle and cannot find a way to remove the key from the ignition. He is a mechanic; the ignition switch doesn't push in, he can't locate a key-release button, and there doesn't seem to be any position in "off" that allows for the...

OK hopefully you omeone can help me diagnose. Here is the story. My wife was driving on Saturday and she said the car just seemed to "pop out of gear". No noises or weird vibration, just no drive. This was on the highway, so figure 65 MPH. She pulled over immediately, put it in park, tried drive...